Oldsmobile Intrigue
Income Garnishment
Transportation Security Administration (TSA)

What is wrong with your 1999 Olds Intrigue when flashers work only part of the time?


Top Answer
User Avatar
Wiki User
2006-03-22 13:54:50
2006-03-22 13:54:50

You have to replace the smart stalk. if you want a permenant fix. You can get them woking again by repeatedly depressing the hazard warning button.

User Avatar

Related Questions

The 1999 Olds Intrigue does have a dipstick. Use a funnel to add fluid as needed into the dipstick tube.

The oxygen sensor on a 1999 Oldsmobile Intrigue 3.3 liter is in the exhaust manifold/pipes

What does 'service engine soon' light mean on a 1998 olds intrigue?

A 1999 model year vehicle will use R134a refrigerant.

Answer confusedhow to change a timing chain in 1999 Oldsmobile intrigue

I have a 1999 Oldsmobile Intrigue 3.5 liter, I will like to know were the Timing chain marks.

Inside the engine. You have to take the oil pan off.

Car will not start, makes no sound. Battery is strong.

To remove the shift knob on the 1999 Olds Intrigue look for the pin that is holding the knob in place. Remove the pin and pull up on the knob, replace kob and pin.

Where can I find a engine schematic on line, for a 1999 Oldsmobile Intrigue 3.5 V6.

On the bottom of the overflow / surge tank (passenger-side fender)

As long as they're not electronic parts, probably. Check a parts web site like AutoZone or Advance and compare the part numbers. If they match up, you're all set.

On the 99 Olds Intrigue, the camshaft sensor is located on the rear of the engine. It is just above the starter.

Underneath the coil packs, which are the square black rectangles with the seven bolts holding them down.

Two that cool the radiator (under the hood) and one that blows out the vents (behind the glovebox)

It is normal for the compressor to cycle on and off If it is cycling excessively could be due to an incorrect refrigerant charge

The camshaft sensor on the 99 Olds Intrigue is located on the engine block. It is under the starter, which has to be removed to locate the camshaft sensor.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.