5.7 liter vortec.
every engine needs fuel, air, and spark. which is it not getting?
NO it will not. The bell housing is different.
The Chevy SBC 5.7L 350cid V8 was the standard
NO it will not work. There is ONLY 2 years that will interchange with the 97 year truck. That is a 1997 and 1996 4L60E transmission.
NO. There is only 2 years that will fit in the 96 and that is a 1996 and 1997 4L60E.
Could be a blown fuse.
Yes but modification will be needed
The recommended spark plug gap on a 1996 Chevy C1500 with a V8-305 engine is .060"
Engine oil, 4.5 qts with filter change.
What is the refrigerant capacity in a 1996 Chevy 1500 4.3
where is the orifice tube location on a 1996 GMC pickup truck 1500
Try the lower rear of the engine - try to follow the + battery cable
It will be on the left bottom side, towards the rear of the engine. while standing in front of the engine.
Where what! What is your question?
it is in the distributor
You would find it in the front of the engine driven by the accessory belt.
no the 96 steering wheel is different
No it does not, GM. did not start using roller cams until 1996.
Check your gas cap. Make sure the seal is still good. This will cause the check engine light to stay on and is an easy fix.
The most common engine used was the 5.7L 350 V-8. But it may have the 6 cylinder in it. Count the spark plugs.
All V8 engines have the same firing order. 1,3,5,7 is the left bank, 2,4,6,8 is the right bank and the distributor rotates clockwise. 1,8,4,3,6,5,7,2
If it is the VORTEC engine then it is bolted to the passenger side of the timing cover on the front bottom side of the engine. If it is the TBI / THROTTLE BODY INJECTION engine then it don't have 1.
The fuel filter is under the body, midway mounted on the frame rail. it is a canister type, and takes an open end wrench, probably a metric 14.
Most common cause is. Bad plug wires and or bad spark plugs. Time for a GOOD tune-up.
were is pressure regulatore on Chevrolet silverado 1500 5.7
Look at this: http://autorepair.about.com/library/firing_orders/bl-fo-5830.htm
i second would like to know.i have a 454 97 suburban and a 1500 pick up.i want to keep the 1500 but needs a motor.i already installed the 454 transmission on the 350 vortec but just learned the 350 is tired
firewall 8 - 7 6 - 5 4 - 3 2 - 1 front
It just unscrews, It is real tight.
It depends on the gear ratio of the rear ends. You can find this out in the glove compartment of your truck. It should tell you there. Hope this helps you out.
you won't,but it will fit as you can install any Chevy big block in it,may have to modify motor mounts- sounds like a fun project, good luck
That will be a 4L60E transmission.
NO. They are different.
how to tell if my crankshaft sensor is not working
hi there. i just did mine, and it has to be 14 to 16 pounds on line. on plug your line to the carb and put the meter on there and see. cheers!
same way you would on any other vehicle
The oil pressure sensor is located on the back of the engine, next to the distributor.
how maany fuel injectors a 1996 Chevy c-1500 NEW ANSWER: It has 6 and they are underneith the upper intake.
Chevy did not use a reset / Inertia switch on there trucks.
Follow the spark plug wires.... :)
That would be a 4L60E transmission.
Its non-adjustable, i have the same year truck, 5-speed as well.
1-6-5-4-3-2 clockwise on distributor.
There is not 1 on that year. They were NOT used untill 1996
raise the bed up it would be easier
My 1996 is governed at 100 on the dot.
That year must have the 1996 4L60E transmission put back in it.
chevy what? need engine size
It has a electric fuel pump inside of the fuel tank.
Yes, it is possible for the 1996 Chevy C/K 1500?æto tow cars. You need to just make sure to have the proper equipment.?æ