answersLogoWhite

0


Best Answer

the hinge is a bolt in the door at the top and bottom and the door slides on a track

User Avatar

Wiki User

8y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What kind of hinge is needed for two panel door to fold back completely onto one panel?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

When was Lobatse hinge-back tortoise created?

Lobatse hinge-back tortoise was created in 1927.


When was Speke's hinge-back tortoise created?

Speke's hinge-back tortoise was created in 1863.


When was Natal hinge-back tortoise created?

Natal hinge-back tortoise was created in 1935.


Does the elbow joint include a hinge joint and a gliding joint?

The elbow is a hinge joint. When you think about it, you can only bend your elbow back and forth. Think about your wrist, that's a gliding joint. It moves in a completely different way than your elbow.


What type of joint found in the elbow?

It's a 'hinge' joint - it can only move in two directions (forward and back).


How do you remove the door panel on a 1995 Dodge Dakota?

THE DOOR PANEL IS HELD ON BY SPRING CLIPS THAT ARE ATTACHED TO THE BACK OF THE PANEL AND ARE PUSHED INTO APPROX. 1/4 IN HOLE. JUST PULL ON PANEL STARTING AT TO OR EDGE AND YOU WILL SEE THAT IT WILL COME OFF. ITS REINSTERED BY JUST PUSHING BACK IN. You will also need to go and buy a door handle remover if you wish it completely off.


What joint allows the elbow to swing back and fourth?

your elbow does this because it has a hinge joint. a hinge joint is also found in your knee


Replace door hinge 1989 Mitsubishi Triton?

need to replace door hinge pin on 189 mitsibushi Triton tray back


What is the range of motion of a hinge joint back in forth movement?

back in forth movement is the anwser


How do you change a cabin air filter on a 2001 Honda CR-V?

1 Open the glove box of your CRV. Remove the hinge tabs on each side of your glove box by prying them up. This will allow the glove box to swing into a completely downward position and will give you access to the filter compartment.2 Slide the access panel's clip to the right. This clip is located on the left hand side of the access panel. Once the clip is moved, swing the access panel door fully to the right.3 Pull the two filter trays straight out. Once they are removed, you can take out the old filters.4 Place the two new filters in their respective trays. Note the directional arrows on the two filters and make sure they are laid in the filter trays in the right direction to ensure proper air flow.5 Slide the two trays back into place and shut the access panel door. Also slide the access panel lock back into place.6 Partially raise your glove box back up and re-insert the two hinge tabs on each side. Shut glove box once they are back in place.


How do you get a palm treo back off?

With the back panel facing you so you can read the word Palm, press the lower-right corner of the back panel with your right thumb to release the panel. Remove the panel.


What is hinged joints?

A hinge joint is a joint that allows forward and backward movement. Your elbow and knee are hinge joints.