Cars & Vehicles
Ford Expedition XLT
Dodge Dynasty
Suzuki XL-7

What kind of motor oil does a 93 dodge dynasty need?

161718

Top Answer
User Avatar
Wiki User
Answered
2006-03-24 23:02:54
2006-03-24 23:02:54

Any kind of name brand 10w-30 oil should work just fine.

012
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The blower motor is located on the passenger side of the dash. You will need to remove the glove box and the underdash panel. There are 4 fasteners to the cover, two screws in front and two nuts in the back.

yep but you need to take motor mounts and ecm and wiring

A 2003 Dodge motor will fit in a 2002 Dodge Durango. The motor mounts may need to be changed, in order for the engine to sit correctly.

i have a 1970 dodge dart with a slant 6, 225 and need to know if a 318 out of 1970 dodge dart will mount up with the motor mounts and tranny.

crysler (dodge is owned by crysler) is notorious for bad transmissions so you might need to get another

5w 30 or 10w 30 will work just fine

dodge factory speaker sizes are 6"x9"

What you need to do is open the trunk. Then you need to remove the liner in the back of the trunk closest to you then you can see the wires the twist out.

You need to remove the wiper transmissions, linkage and motor assembly as one unit then separate the motor from the rest on the work bench.

if it is the same size and year then yes but you will need oil pan off dakota.

Not easily. You will need a different computer and wiring harness.

yes but u need to go to the place where you brought the to ask the car dealer

Atf3 or Atf4 is the transmission fluid for a dodge caravan.

It is the two wire sensor screwed in next to the thermostat housing.

yes I've done it but you will need the 3.5 trans, wiring harness engine and trans pcm and both axles you will need to get that out of a 300m

you probably need to clean and re-grease the window motor

Yes and no, you'll need to replace the computer,trans,motor mounts,front exhaust pipe and possibly the wiring harness, not a job for the inexperienced

No, you need a 2.7, or preferably a 3.2 or 3.5 liter between 1998 to 2004 for this car. It will probably cost more than the car is worth to replace the motor at this point.

There is no certificate need for your 16 year old to operate motor boats legally

Take a 15mm open end wrench and fish it under the motor mount and place it on the nut to the tension pulley. Use a piece of wood or something to push down on the other end to get the leverage you need to relieve the tension on the pulley

What torque specs do you need? Also, what size is your motor and manual or auto tranny?


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.