Transmission Fluid

What kind of transmission fluid and how much for a Chevy 1983 blazer S-10 take?

012

Top Answer
User Avatar
Wiki User
Answered
2014-06-13 22:24:02
2014-06-13 22:24:02

A 1983 Chevy Blazer transmission will hold 12 quarts of transmission fluid. The manufacturer recommends using a. SEA certified transmission fluid.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Where is the control module located on the 1983 Chevy blazer

The gross weight for a Chevy Blazer 2 door 4x4 is 5300 pounds. The Chevy Blazer was produced from 1983 to 2005.

How do I check the transmission fluid on a 1983 Honda Civic 1500DX

The wiring diagram for a 1983 Chevy Blazer can be found in the service manual. It contains a detailed layout of where each wire goes and its function.

Any 1983 - 1993 S10, and 1983 - 1994 Blazer, Jimmy, or Bravada.

It does not matter on that year, as long as it is PS fluid.

It will fit but you will have to get a shorter driveshaft. The truck transmissions are longer then a passenger car transmission.

Passenger side way back dipstick. You will need a transmission funnel. Use Dextron III fluid.

Assuming it's a V8-equipped Caprice you're referring to, it shared the same transmissions with the Camaro, Malibu, full-size Blazer and Silverado pickups

You would add transmission fliud thru the dipstick opening.

Your 1983 Chevy S10 Blazer might stall when the accelerator pedal is depressed because of a clogged or dirty fuel filter. Gas that is mixed with water or condensation from the tank can also cause this issue.

Mazer Blazer - 1983 VG was released on: USA: 1983

I buy transmission fluid from the dealer since it is a "synthetic oil" type fluid. Brake fluid is DOT-4 from anywhere althogh you can price it at the dealer.

th 400 th 350 if it has over drive 700r4

The 1983-1994 Chevrolet Blazer S-10 (sometimes called "Compact Blazer") takes 16" replacement windshield wiper blades on both sides front. The 1989-1994 models also take a 14" rear wiper blade.

Back then the headlight circuit was protected by a circuit breaker that was built into the headlight switch.

you use a funnel to put it down the same tube that the dipstick came out of.

A fuse diagram for a 1983 K5 Blazer is helpful for mechanics that need to make repairs on the car. The diagram can show the mechanic where exactly the parts are for the Blazer.

The shaft inside the trans will have to be changed it is longer in a 2 wheel drive and the taIL SHAFT.

You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.

Stanard transmissions use oil, not transmission fluid. There is a plug on the side of the tranny. Open the plug and stick your finger in. The oil should be right at the bottom of the opening. If not, you will need a pump to get the oil into the tranny.

90% of the parts from any 1982 to 1993 Chevy S-10 or GMC S-15 (Sonoma). 85% of the parts from any 1982 to 1993 Chevy S-10 Blazer, or S-15 Jimmy

yes 1973 to 1983 will work because this is before 1984 when wipers moved to the column in the full size trucks. it will bolt right in directly. good luck


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.