Distributors and Distributor Caps
VW Golf GTI
Chevy Blazer S-10
What makes a 90 GEO Storm GSI dual overhead cam fire on only 2 cylinders after I have replaced coil coil and plug wires distributor cap and rotor and set timing?
Asked in Honda Civic
What is location of number 1 cylinder on a 1994 Honda civic?
When does the timing chain in a 1999 Jeep Grand Cherokee have to be replaced?
Asked in Timing and Firing Orders
Is there a way to set the timing from the distributor cap?
Asked in Dodge Dakota, Timing Belts and Chains
How do you set initial timing on a 96 dodge Dakota 3.9L after timing chain and distributor have been replaced?
How often should you replace the timing belt for a 1997 Ford Ranger?
Asked in Oldsmobile LSS, Oldsmobile Achieva
Does replacing water pump have anything to do with a timing change on a 1997 Oldsmobile lss?
Asked in Nissan Maxima
Your 89 Maxima engine was replaced with a 1992 how do you know if it is a VG30DE or VG30E?
Asked in Toyota Tacoma
Does 2000 Toyota Tacoma have a timing belt?
Asked in Cars & Vehicles
What is the timing chain?
Asked in Nissan Maxima, Timing Belts and Chains
Does a 1993 Nissan Maxima have a timing chain or belt?
Asked in Honda Accord
Does all Honda Accord with 4 cylinder have timing chain?
Asked in Honda Civic, Honda Civic CX
Is the number one cylinder closest to the distributor or the timing belt?
Asked in Fuel Filters
If a 1993 Geo Tracker has a rough idle and you have replaced the plugs wires distributor cap rotor and fuel filter what is next?
Asked in Nissan Altima
How do you adjust a timing chain on a Nissan Altima?
Asked in Chevy Blazer, Chevy S-10, Chevy Blazer S-10
How do you time a 91 s10 blazer 4.3 v6?
Asked in GM and GMC
Where is the timing sensor located on a 350 1998 gmc truck?
Asked in Ford F-150
How do you set the timing on a 1992 ford f150?
The timing is set by timing marks on the crankshaft pulley. Using a timing light the light will sync with the engine and show if the marks line up properly. To adjust the timing the distributor is turned slightly. There is a clam and bolt under the distributor, loosen these just a bit to be able to move the distributor.