answersLogoWhite
Chevy Silverado
Chevy Trucks and SUVs
Chevy S-10

What rear end is in your stock 1987 Chevy 34 ton truck?

212223

Top Answer
User Avatar
Wiki User
2006-12-26 23:30:34
2006-12-26 23:30:34

probably different than yours- these vehicles were available with a multitude of various drive components-crawl under and take a look at axle- write down the info staped on the centre housing and call dealer,they will supply info regarding the axle number you provide.

1

Related Questions

User Avatar

What are the dimensions of 05 Chevy truck

User Avatar

A 1977 Chevy pickup truck would have rotors in front and drums in the rear

User Avatar

chevy suburban is mounted on a truck frame so most rear ends from any truck or tahoe which is also a truck will work if it is a late model 6 lug.

User Avatar

On the front of the truck, rear hinged.

User Avatar

how to replace the rear seals on a 1991 Chevy S-10 pick-up truck

User Avatar

There is an article by wiki answers here: or follow the link in the link section below. If you don't want to do the job yourself consider contacting an online auto glass shop for quotes for the Chevy rear window. http://wiki.answers.com/Q/How_do_you_remove_a_1989_Ford_Ranger_rear_window_and_install_a_sliding_rear_window

User Avatar

The 87 comaro if stock takes GL90 gear oil , if its a posi you will need a special additive Good luck

User Avatar

Under right rear of the vehicle, In front of the rear axle...

User Avatar

The length of the 1969 stock Chevy Nova rear end is sixty and 1/4 inches at its widest point. This includes the width of the rear hubs.

User Avatar

Is a rear end in a 88 4x4 Chevy truck the same as the front in gears of a 93 Chevy 4x4

User Avatar

The stock gear ratio for a 1995 Chevy Blazer is 3.73. This provides a good balance of fuel economy and power to the rear wheels.

User Avatar

the rear end is prob 3:42 limited slip rear end

User Avatar

My Chevy truck doesn't stall. It actually runs very good because I take good care of it and do a weekly inspection of fluid levels including the rear axle.

User Avatar

Will it bolt in? No. But anything will fit with fabrication and money.

User Avatar

The rear brakes on a 1984 Chevy truck are drum brakes.

User Avatar

It depends on the gear ratio of the rear ends. You can find this out in the glove compartment of your truck. It should tell you there. Hope this helps you out.

User Avatar

Chassis Engineering Inc has a kit to install a motor, transmission and rear end into a 1951 chev truck.

User Avatar

shoud be 6.75 in door 6.5 will work and 4x6 in rear


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.