I used a 7/32 socket but it's probably a metric. The heads are really soft so don't over-torque them.
where is the ignition control module loacted on a 1997 chevy cavalier
how do you replace ignition switch on a 1992 Chevy cavalier 2.2 4 cylinder
Remove the retaining ring from the top of your 1999 Chevy Cavalier ignition switch. Slide the ignition switch out and remove the wiring harness from the end of it.
i have 85 cavalier how you get key cycliner out
The steering and ignition will become locked on a 97 Chevy Cavalier if the key is not inserted into the ignition and turned. This helps to prevent theft.
the ignition coil on a 2004 chevy cavalier is the black part on top of the engine were it says eco 2.2 but its not hard to miss its very easy to change as well
I have a 97 Cavalier,,,and one key does the door , ignition and trunk.
unless you get a new radio installed, an FM modulator is your only option
it is located behind the coil packs
It is located by the ignition switch on the right side of the steering column.
Because something on that supply line has a problem
You'll need a new ignition switch and key provided from your dealer, the bill won't be pretty!
IF IT IS A 4 CYL YOU PROBABLY HAVE A BAD CRANK SENSOR OR IGNITION MODULE.
The ignition switch, or "killswitch," for a 1996 Chevy Cavalier is located inside the steering column. Replacing or repairing it requires disassembly of the steering column.
Th350 has a modulator on the back. Th400 has modulator on side. 700R4 has no modulator.
It depends on what engine yu have but on a lot of them it is under the coils. If your car has a dist it is inside.
see if the coil is sparking to the distributor cap
There is probably a leaky connector seal somewhere or possibly a little water gets in the distributor, provided that your cavalier is old enough to have a distributor. Check the connectors, especially around the ignition distribution. You can seal connectors with a little silicon grease, but if there is any damage, just replace the part.
my ignition module for a 93 s10 was hld by two small bolts on top of the distributor. don't drop one of them into a storm drain they are not easy to buy.
You need to turn the wheel (about 1/4 inch) to relieve the pressure while you turn the ignition.
i do not know go to a car stereo install ... store
firing order for Chevy cavalier