Ford Ranger
Ford Ranger XL
Ford Ranger XLT

What size brake drums does a 1991 2 wheel drive Ford Ranger have?

012

Top Answer
User Avatar
Wiki User
Answered
2013-11-10 19:04:58
2013-11-10 19:04:58

On a 1991 Ford Ranger :

Either 9 inch or 10 inch brake drums

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


You could have either 9 inch or 10 inch brake drums


According to Motorcraft.com - YES Both the 2006 and 2007 Ranger front brake pads are # BR 11438 for all 3 available engines , 2 wheel drive and 4 wheel drive


Remove the tire and wheel from your 1988 Ford Ranger pickup truck. Remove the brake pads. When the brake drum is not loose you can tap on it with a hammer or mallet. Once the brake drum is loose it will slide off.


A 1998 Ford Ranger is rear wheel drive ( or 4X4 capable )


Rear wheel drive or 4 wheel drive capable


rear wheel drive ( and maybe 4 wheel drive capable )



rear wheel drive ( or four wheel drive capable )


They should. As far as I know, they have the same number of lugs.


rear wheel drive ( and maybe 4 wheel drive capable )


No. The Contour is a front-wheel drive car, and the Ranger is rear wheel drive.



no , it's rear wheel drive or 4X4 capable


No , rear wheel drive or 4x4 capable


It is inside the rear brake drums. It is the part that pushes the brake shoes out against the drum.It is inside the rear brake drums. It is the part that pushes the brake shoes out against the drum.


The wheel cylinders are generally located inside the wheel drums on cars and trucks. They work the brake shoes.


flat tow 4 wheel drive ranger


There are more than one brake line(s) on the Ranger vehicles. The exact length of any given one is according to the Ranger model vehicle; eg: 2-Wheel drive, 4 Wheel drive, Regular car or extended cab etc. You can get a rough estimate regarding the length of just about any of the lines by looking under the vehicle and following them from their respective ENDING location to the MASTER BRAKE CYLINDER under the hood (driver's side).


Yes, there is a cable that runs to the rear wheel brake drums.



what are the pins for on a wheel drum?



Brake drums are not attached with fasteners, they just pull off once wheel is out of the way.


2002 ranger wont go in 4wheel


jack up truck on stands, take wheel of , brake pads, then rotor lock nuts, rotor, after there are 5 nuts (15mm) take them of and that's all.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.