Typically when building a home without a specific model of refrigerator determined in advance, the refrigerator is assumed to be 36" wide by 69" tall. Because of differences in floor heights, refrigerator hinge heights and cabinet door swings (cabinet doors above the refrigerator can bump into refrigerator top mount hinges), add an inch or two to the height of the opening. A safe opening size would be 36.5"-37" wide and 70"-71" tall.
Generally about 36 inches
That would depend on the refrigerator.
The ring size is 23.
A dorm size refrigerator is typically best for small apartments. These can hold milk, beer, and eggs.
No
where is the water filter
For a standard size refrigerator, a dedicated 15 amp circuit is used.
It's not a question of opening size but a question of loading over the opening. No load, no lintel. If a 12 inch opening is capped with a 16" block, the block is the lintel. If an opening is between wall studs there is little need for anything that would be called a lintel. Anouther name for a lintel is a header. There is usually some kind of header over an opening. A lintel's size and integrity is determined by the load it will support.
form_title= Small Refrigerator form_header= Install a small refrigerator in your kitchen. What size refrigerator do you want?*= _ [50] Do you want a freezer on top?*= () Yes () No Do you want an energy efficient refrigerator?
Depends on the refrigerator. Check the owner's manual for the right size.
cats
The circuit for the refrigerator is overloaded. The full size refrigerator typically requires a dedicated circuit.
form_title= Compact Refrigerator form_header= For a little space, purchase a compact refrigerator. What size do you want the refrigerator?*= _ [50] Do want a small freezer too?*= () Yes () No Do you want an energy efficient model?*= () Yes () No
Whether it is blanking or piercing, size of opening in sheet is governed by punch and size of cutout piece is governed by Die. So, for piercing, Punch size should be same as required hole size and clearance should be given on Die. For e.g for a hole size Dia 8, punch size should Be 8mm and die size 8 + clearance For Blanking, DIe size should be same as size of blank and clearance should be give on punch. So for a blank of Dia 8, die size is of 8mm and punch size is 8 - clearance.