answersLogoWhite

0


Best Answer

A 600 amp service for a residence is not in the normal range of residential wiring. The service will require special metering and installation procedures along with consultation with utility company and the electrical inspector. Most home wiring electricians are limited as to the amount of current their licence will allow them to install. This is usually 200 amps.

Two parallel 350 MCM conductors with an insulation factor of 90 degrees C will give you an ampacity of 650 amps.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What size service wire for a 600 amp residential service if run parallel on the riser?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What size conductors are needed to run a 400 foot residential underground electric service?

Need to know what size service is going to be installed at the end of the run.


What size service ground is needed for a 350 parallel service?

From the question it is hard to establish whether the service size is 350 amps or the service conductors are 350 MCM in parallel. If the service is 350 amps, the grounding conductor is #3 bare copper wire. Parallel 350 MCM conductors will allow for a 600 amp service. The grounding conductor for a 600 amp service is a #1 bare copper wire.


What is the minimum service size for a 225amp residential service?

A 200 amp service panel with a 60 amp sub-panel.


For a parallel feed to a 1200 Amp service 3 phase what size is the grounding electrode to main service with 3 600 mcm parallel runs?

500 mcm


What size service conductors do you need for a single phase 600 amp commercial panel?

The size of wire for service entrance conductors for a 400 amp 3 phase service could be 500 MCM copper. This is very large size wire and difficult to bend and shape, to connect to terminals in the main disconnect and distribution panel. This problem is solved by using parallel conductors or on higher ampacities triple conductors. Using parallel conductors the wire size would be three ought (3/0) copper.


What is the wire size needed to feed a 400 amp service with parallel copper?

It depends on the length of the run


What size copper wire to use for a 100amp single phase three meter service feed from the riser?

A #3 copper conductor with an insulation factor of 90 degrees C is rated at 115 amps.


What size ground wire for 100a service?

A 100 amp residential service requires a size #8 copper wire, it should be insulated in green.


What is the minimum size neutral for three sets of parallel 500kcm copper conductors for a service?

On large service entrance services the neutral can be reduced. The amperage of the service and the voltage of the service and the insulation factor of the 500 MCM conductors need to be stated to answer this question correctly.


What size wire is needed for 1600 amp service?

4 sets of 750 mcm aluminum. Or four parallel runs of 600 MCM copper.


What is the typical size of a residential PV system?

depends on your needs


What is the size of a parallel parking in the ohio drivers test?

parallel parking dimensions ohio