That requires a special socket made just for oil sending units. Your local auto parts store can sell you one.
Above the oil filter, where it screws on. You'll need a special socket to remove/install a new one.
It is a 36 MM socket
yes, you will need a oil sending unit socket and should be located at rear of motor, towards firewall. Check with auto parts store near you for socket and ask for a print out of exact location of unit. Have a good day and GOD BLESS.
This may sound bad but it really is this easy. Find O2 sensor (there are two or three and some have four) that you need to change Unplug from wiring Remove using wrench or special socket if you have the special socket Screw in new gently! Plug in.
36mm
The oil pressure sending unit is located on top of the motor beside the base of the distributor. You will need a special socket from your parts store to remove/install the sending unit without harming the new one. The socket is not expensive and does fit sending units for other cars.
5/8 inch spark plug socket.
Need a special socket. They are located in the exaust manifold(s).
The sending unit is in the middle of the block on the drivers side.. You will need a deep socket to get it out.. Not easy to get to.. Looks like a big spark plug.. Mike
A 2014 jeep Wrangler will need 6 quarts of oil for an oil change.
You need a 5/8" spark plug socket.
youll need a 5/8 superdeep plug socket