answersLogoWhite

0


Top Answer
User Avatar
Wiki User
Answered 2006-12-29 20:36:58

5/8" ratchet works fine

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...
Still have questions?

Related Questions

How do you change a serpentine belt on a 94 grand am?

You will need to loosen the tensioner pulley on your 1994 Pontiac Grand Am. The old serpentine belt will come loose and can be removed. Put the new serpentine belt on and tighten the tensioner pulley.


How do you change a serpentine belt on a 1992 jeep grand Cherokee?

The Jeep Grand Cherokee did not exist until 1993.


How to replace Serpentine belt on 1992 grand AM 2.3 l?

how to replace a serpentine belt on 1992 grand am 2.3l


Will a serpentine belt change on a 90 Pontiac grand prix require removing engine mounts?

Absoultly not.


How do you replace the serpentine belt in 1997 grand am?

How do you replace the serpentine belt in 1997 sunfire


How do you replace the serpentine belt on your 1994 Jeep Grand Cherokee Limited V8 5.2 liter?

There is a idle pully that you put a socket and rachet on and rotate it so that it takes the tension off the belt.


How do you install the serpentine belt on a Mercury Grand Marquis?

See related question and answer at: http://www.wikifaqs.com/Q/How do you fix a 1998 Grand Marquis serpentine belt


How do you change the oil filter on a 2012 dodge grand caravan?

Its under the hood you need a 24 mm socket


How do you change the alternator belt on a 1992 grand am gt?

1 of all its called a serpentine belt and u have 2 jack up the engine


How often do you change your serpentine belt on a 2005 jeep grand Cherokee?

about every 60,000 miles. check it for cracks and stains. if its bad replace it.


Does a 1987 Jeep Grand Wagoneer have a serpentine belt?

not from the factory


Where is the Jeep Grand Cherokee serpentine?

The serpentine belt goes around all of your pullies in the front of your motor, behind the radiator.


How do you loosen the tensioner to replace the serpentine belt in a 1993 grand Cherokee?

There should be a place on the tensioner to insert a ratchet wrench or breaker bar without a socket or a "nut" for a socket to fit. Turn the tensioner clockwise or counterclockwise to loosen the tension (some tensioners rotate clockwise and some counterclockwise) and remove the old serpentine belt - NOTE: be sure and note how the belt is routed so you can install the new one in the same routing.


How do you replace a serpentine belt on a Pontiac grand prix GT wit a 3.8 liter engine?

The serpentine belt can be removed by using a rachet/socket and turning the spring loaded tension pulley clockwise. Reverse the order to install the new one. (The pulley should be somewhere in the top/middle section of the drive area.


How do you change the oil on a 1994 Pontiac Grand Prix?

with an oil drain pan and a socket...make sure you have more oil to put back in...


Does anyone know what size torx socket is needed for the upper attachment brackets to change out the rear door strut supports on a 1996 Grand Cherokee Laredo?

Hi- The numbers on my socket are "E8 S-K"


Diagram for installation of serpentine belt on a 2003 grand marquis?

diagram for 2003 grand marquis belt installation


What does the serpentine belt on a Pontiac gtp run?

i have a 98' Pontiac grand prix gtp. i got the 2 serpentine belts replaced for $200.


Do you put on a serpentine belt on 1995 grand am?

yes you do otherwise nothing works


What size socket do you need for a axle nut on 2000 jeep grand Cherokee?

u need a 36mm socket!


How do you change the alternator for a 1995 Grand Caravan?

Remove battery connections, then slacken the serpentine belt. Removal of alternator is simple and straightforward, 3 bolts, replace in reverse order.


How do you replace the serpentine belt located on a Jeep Grand Cherokee Laredo?

For the 1999 Jeep Grand Cherokee Laredo, you'll need a 1/2" socket wrench. The longer the wrench the better, i.e. a long breaker bar. The spring retention arm has a square hole for the 1/2" socket to be placed. Once placed, you can adjust tension for serpentine belt removal or application. Follow the belt route guide on the "little sticker" near the belt under the hood. If you don't have a 1/2" socket wrench, I'm pretty sure you can rent the necessary tool at Autozone for free (deposit returned when tool returned). This method works for many different vehicles, makes, and models.


How do you change a brake light bulb in a 2001 Pontiac grand prix?

Open the trunk, locate and remove the defective bulb from the socket assembly in the tail light assembly. Replace the bulb with a new one, and lock into socket. Close trunk.


Routing for serpentine belt on 1997 grand prix with the 3800?

There is a picture in the motor compartment.


What is the oil capacity of a 1990 Mercury Grand Marquis?

5 U.S. quarts with filter change ( according to my Chilton's repair manual ) for the 302 or 351 cubic inch V8 engines ( 5.0 or 5.8 liter V8 engines )