0
What size specialty nut do you use to remove the caliper mounting bracket in a 93 chevy lumina?
Wiki User
∙ 12y ago
T60. It's a torx bit.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What size is the brake caulaber bolts on 93 Chevy Lumina?
15 mm is the size,for caliper bolts caliper bracket bolt is t60(it is star shaped)
Are Chevy euro and Chevy lumina coil packs interchangeable?
Yes....In fact, any 87-96 (maybe later even) coil packs from a 2.8, 3.1, 3.4, 3100 SFI etc will interchange. The only thing that changes is the mounting location and bracket. The 3100 moved the pack to the top of the engine and had to change the mounting bracket. But the ICM and coils can be removed and put on your original bracket.
How do you change the rear rotors on a 1998 Chevy Lumina?
Remove the 2 bolts from the caliper and then the 2 to the caliper bracket and just take off your rotor. Installation is in reverse of removal. Just make sure to put anti-seize on the bolts before putting them back in
How do you change front brake rotor on 1997 Chevy Lumina?
AnswerRemove wheel Remove caliper (2 15 mm head bolts) Remove caliper mounting bracket ( requires special large torx socket, forget exact size, available at Sears) Rotor will now fall off practically. after machining or replacement, reverse process above. Should take less than an hourThe torx socket size is T-60.
Will a 96 Chevy Lumina air conditioning compressor fit on a 95 Chevy Lumina?
No, the compressors and mounting points are different on the 95 Lumina
How do you change the rotors and pads on the front of a 1995 Lumina van?
Remove wheels Remove caliper mounting bolts Slide caliper off rotor Rotor should slide off hub Use a "c" clamp rto fully retract piston into caliper body Replace rotor Replace inner and outer pads Replace caliper PUMP BRAKE PEDAL TO SET PADS AGAINST ROTOR PRIOR TO MOVING VEHICLE
How do you change the lug bolts on a Chevrolet Lumina?
take a punch and a hammer and punch out the wheel stud from the front, then slide the new stud in from the rear. take a lugnut and thread on the new stud and tighten down with a 19mm impact socket till very tight. It would also be easier if you remove brake caliper, caliper bracket and rotor.
If the left rotor on your '93 Lumina is rusty does this indicate the caliper is not working?
YES! If the car has been in use could be the caliper the caliper slider or the brake hose connected to the caliper. yes, if the car has been in use and the rotor is rusty then the caliper is frozen and needs to be taken apart and replaced.
What tool to take off caliper 1997 Chevy lumina?
3/8" hex bit socket.
What size are the caliper bolts on a Lumina?
its a 6 side star type socket the size should be a T60
How do you remove rear brakes on a 2000 Chevy Lumina?
Begin by removing the tire and wheel from your 2000 Chevy Lumina. Remove the brake spring and the break caliper. The rear brakes will come off.
What size torx bit do you need to remove the bracket that goes around the rotor on a 96 Lumina LS?
T10
