0
A #3 copper wire with an insulation rating of 75 or 90 degrees C is rated at 100 and 110 amps consecutively.
As for the voltage, wire is usually rated in 300, 600 and 1000 volts. Any three of these insulations factors will handle 12 VDC.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What size wire for 12vdc 35 amps?
A #8 wire with an insulation rating of 75 or 90 degrees C is rated at 45amps respectively.
What size wire for 12vdc 30 amps?
A #10 wire with an insulation rating of 60,75 or 90 degrees C is rated at 30 amps respectively.
Explain wire size as opposed to gauge size?
see American Wire Gauge. The larger the number the small the wire size.
Is neutral wire same size as hot in 200 amp panel?
Yes, they are the same size wire.
What size of wire should be used for 60Hz?
The frequency has no direct relationship to the size of wire. Wire is sized as to the amount of current a load draws in a circuit.
What size wire do you need for a 100amp braker?
Service entrance wire should be AWG #3 copper.
What size wire for 12vdc 35 amps?
A #8 wire with an insulation rating of 75 or 90 degrees C is rated at 45amps respectively.
What size wire for 12vdc 30 amps?
A #10 wire with an insulation rating of 60,75 or 90 degrees C is rated at 30 amps respectively.
What size copper wire to use for a 100amp single phase three meter service feed from the riser?
A #3 copper conductor with an insulation factor of 90 degrees C is rated at 115 amps.
How do you wire 12V AC to 120V DC?
You would need a 12VDC to 120VAC power supply.
How do you check the fuel solenoid on Briggs 18 hp ohv engine?
Switch the ignition to on. Put your meter to 12VDc. Touch the hot wire going to the solenoid with the meter positive probe . Touch the meter negative probe to ground. If you have 12VDc and you don't hear a click when you turn on the switch, the solenoid is probably bad. If you don't have 12VDc, check fuses and the wire going to the solenoid.
What is the minimum wire gauge acceptable for a 150watt 12VDC circuit?
I'd recommend the table at: http://www.windsun.com/Hardware/Wire_Table.htm
What wire size for 100amp load for distance of 1000ft?
At that distance you will have a voltage drop of 81.25 volts if you use the recommended #6 wire on a 240 volt, 100 amp single phase circuit. Therefore I recommend you contact you electric utility and let them figure the voltage drop and the size wire required to safely run this distance. Using too small a wire can damage the electronics at the end of the run.
Can you use 12VDC in New Zealand?
Almost all cars in NZ have 12VDC electrics. Most portable generators which produce 230VAC, will also have a 12VDC accessory output for battery charging, etc. There are no general reticulations of 12VDC.
How many single phase can you run on a 100amp 3 phase?
You can divide a three phase service into (3) single phase circuits providing you have a 4th neutral wire.
What is the maxi fuse resistance?
100amp
How can i make a winding of a transformer of an inverter of 12vDC to 240vAc?
850va 12vdc inverter transformer praemari tans
