no need to answer. I found out all by myself. 26MM
You will need to remove the exhaust manifold retaining bolts in your 1993 Chevy Astro. Remove the exhaust manifold. Remove the exhaust manifold gasket and clean the surface. Reverse the process to install the new exhaust manifold gasket.
Remove the exhaust pipe from the exhaust manifold. Remove the manifold bolts. Remove the manifold. Remove the manifold gasket and clean the surface. Reverse the process to install the new manifold gasket.
Remove the intake manifold, exhaust manifold, and then remove the head.
Are you trying to remove the exhaust manifold,the muffler,or just the line running from the manifold connection to the muffler?
i have a 1998 ford Triton f 150 how do i remove the exhaust manifold right side
Under the front exhaust manifold. You have to remove the manifold to remove the starter.
You have to remove the exhaust pipe from exhaust manifold on starter side. Now you have access. Get exhaust pipe to exhaust manifold gasket first, you will probably need to replace it after taking them apart.
You have to remove the exhaust manifold to get to the starter.
You just unbolt it. You first have to disconnect the exhaust pipe from the manifold then remove whatever you have to allow you to access the bolts and remove the manifold. It varies greatly from engine to engine. Some are easy and some are very hard.
It is usually bolted to the exhaust manifold, one except is the srt neons had a one piece exhaust manifold/turbine housing.
I D K
Remove the front exhaust manifold and remove it from the top.
The exhaust intake manifold is held in place with 10 retaining bolts. Remove the retaining bolts and the intake manifold will come off.
What engine???????? You should refer to repair manual if not familiar with auto repair and understand the terminology before attempting Remove nuts holding exhaust manifold to cylinder head & remove nuts/bolts holding exhaust manifold to exhaust pipes Use new exhaust manifold gaskets and install the new manifold securing the manifold to cylinder head (may need to but new nuts and or bolts) by "snugly" tightening manifold to cylinder head if not refering to repair manual
Usually just a ratchet set and wrenches.
it's in the down pipe coming from your exhaust manifold. you will have to remove the heat shield from the exhaust manifold to access it
Yes, they share the same gasket and bolts.
Its a bit of a job because it is held on by the same bolts as the intake manifold, and the easiest way is to remove them both, otherwise the rusted exhaust bolts holding the tubing to the manifold is the worst.
2.3L quad 4 is located under the exhaust manifold passenger side. To replace you have to remove the exhaust manifold.
remove the intake and exhaust manifolds. there are bolts that attach them onto the head and there are bolts near the carburetor that attach the intake manifold to the exhaust manifold.
Remove intake & exhaust manifold, then remove head. Requires knowledge and skill.
Remove the intake and exhaust manifold, then remove the head.
You must remove the exhaust manifold, intake manifold, and then remove the head. This is a major repair that should only be attempted by a pro.
If it's an automatic you will have to remove the exhaust manifold because the thermostat is located on the backside of the engine on the driver's side under the exhaust manifold.