Any type of socket can be used to remove a 91' Cavalier wheel cylinder bolt that looks like a reversed torx. However, make sure the socket is a bolt head socket.
GO TO YOUR LOCAL LIBRARY AND COPY MANUEL
Remove the water supply hose from your 1988 Chevy Cavalier thermostat housing. Remove the thermostat housing bolts. Lift the old thermostat out and drop in the new thermostat.
If we are talking about valve lifters, remove cylinder head and pushrods and lifters will be excessable.
Remove the radiator and take it to a radiator shop.
I believe that is a 3/8 Allen key.
Remove the wiring harness from your 1988 Chevy Cavalier fuel pump. Remove the fuel lines from the fuel pump. Remove the fuel pump retaining bolts. Reverse the process to install the new fuel pump.
i would like to remove the backseat from my 1992 chevy cavalier
My 2003 Cavalier uses a 3/8 hex key. It probably should be the same.
May only be able to fit in an open end wrench.
This is not for beginners. You have to drain the transmission, remove the axles, remove the transmission, install the new cylinder, then replace the transmission, axles, add new synchromesh fluid to the tranny, and bleed the clutch hydraulics. You can get the whole procedure from Autozone's website.
How do you remove and replace wiper switch on 2002 Chevy Cavalier
You must pull the steering wheel off, remove the lock plate, lift the turn signal stat, and rent the special removal tool to remove the cylinder from the column.
is there a special tool needed to remove the oil filter on 1990 buick skylark 4 cylinder front wheel drive?
The clutch bleed valve on a 2.2 liter Chevy Ecotec engine is located on the slave cylinder. To find the slave cylinder remove the battery, as it is mounted underneath the battery tray.
Remove the tire and wheel from your Chevy Cavalier. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing.
Remove the cover from your 1986 Chevy Cavalier radio. Remove the radio retaining screws. Slide the radio out and remove the wiring harness and the antenna cable.
Remove the positive cable from your 1998 Chevy Cavalier battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
To remove brake cylinder from Corsa B, first disconnect and unplug hydraulic lines. Remove the nuts and the master cylinder. Remove the reservoir cover, followed by the brake cylinder.
Disconnect the - battery terminal Raise and support vehicle if needed Disconnect the wiring harness at the top of the starter Remove starter mounting bolts Remove starter
Remove the rear speaker covers in your 1994 Chevy Cavalier. Remove the rear speaker retaining screws. Remove the wiring harness from the back of the rear speakers.
Drain the radiator. Remove the pump belt. Remove the fan and shroud if needed. Unbolt the pump and remove it . Bolt on the new pump. Reinstall the fan and shroud, the belt, then refill the radiator.
Remove the retaining ring from the top of your 1999 Chevy Cavalier ignition switch. Slide the ignition switch out and remove the wiring harness from the end of it.