0
68-70f is adequate for most people.
Wiki User
∙ 11y ago
Anonymous
72
Add your answer:
Earn +20 pts
If you have an electronic thermostat what should your temperature swing be set at?
TWO DEGREES
What temperature in celsius should your thermostat be set at to keep your house cool?
21 cel
What temperature should you set your thermostat in your home for the winter for it to be enviromentally friendly?
As low as you can live with
How can you test thermostat in your furnace?
Set thermostat to desired temperature; lets say, 70 degrees Fahrenheit, a few seconds will go by then the furnace should activate. Once the furnace heats the room to the set temperature the furnace should shut off.
At what temperature should your home thermostat be set while you are on vacation?
41.5 C or 299 Calories 2222 F
What temperature is your central heating thermostat set at?
72
How many watts of electric heaters set on low?
The wattage of electric base board heaters does not change because the thermostat is set on low. The wattage is a fixed value on the heater because of its internal resistance element. The thermostat set on low shuts off at a lower temperature than a thermostat that is set on high. It is the time interval that governs the amount of heat that the heater produces when the thermostat calls for heat. Once the room heats up to the temperature that the thermostat is set at, the heater shuts off. The thermostat is just a temperature switch.
How do you change the temperature on a thermostat?
most of them you cant --factory set
Do you set a home thermostat to on or auto?
Depends on the temperature I desire
Why does Temperature drop in ice cream lab?
Temperature in an ice cream lab shouldn't drop: the thermostat there should be set at the appropriate temperature for keeping ice cream in the optimum condition.
How does a 240 volt hot water heater thermostat test for normal operation?
As with any thermostat it is based on where the set point is on the temperature scale. On hot water tanks the thermostat opens the element circuit when the set point temperature is reached. For example the set point should be around 135 degrees F. When cold water enters the tank, the thermostat closes due to sensing a temperature lower than the set point is set at. When the water heats up to 135 degrees the thermostat open because the set point is reached.To test the thermostat shut the power off at the distribution panel for the hot water tank. To do this test the water in the tank should be up to temperature. Remove the wires from the thermostat that is to be tested. Make a diagram of how the wires were connected. Using a continuity tester (ohm meter works fine) place the leads across the terminals where the wires were connected. If there is no reading then the set point is satisfied and the circuit is open. Leaving the tester leads on the terminals, with a screw driver raise the set point to a higher value. The meter should now show continuity between the terminals. Turn the set point down and the terminal reading should open. If this is happening then that thermostat is operating fine. Reposition the thermostat to the original set point. If you are working on the top thermostat now do the same to the bottom thermostat to see if it is working also.See related link below.
What is the purpose of a regulator?
The purpose of a regulator is to regulate something, to keep a value at a set level. A thermostat is a temperature regulator. You set it to a certain value and then the thermostat will control the heat source so that the temperature stays at the set value.
