0
What thickness of wet paint should be applied to the pavement for the desired dry thickness of 8 mils?
Wiki User
∙ 13y ago
12 to 14 mils
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What should be done after the defective pavement has been removed?
sound the pavement
What should the total stopping distance on dry pavement be at 70 MPH?
You should not be travelling on a pavement at 70 mph!
What is the thickness between water based and solvent paint?
Normal wall paint should be applied at a thickness of 4 mils to dry down to approximately one mil thick. This is true with either oil or water-based coatings.
When finishing the repair the it should the exiting pavement without leaving excess amterial on the adjacent pavement surface?
match
If you have allowed the wheels of your vehicle to run off the edge of the pavement You should?
Slow down but proceed forward and slowly steer back on to the pavement.
Where should you park when your tire suddenly deflates on a highway?
Off of the pavement
Isuzu Rodeo rear rotor thickness?
The rear rotor thickness should be three quarters of an inch, when new. The rotor should not be reused when the thickness is less than one half inch.
It is the thickness or width of the index finger?
Technically its width but if you are talking to someone they should know what you mean by thickness.
What should you do if the front right wheel of your vehicle runs off the pavement while driving down the highway?
Apply the brakes immediately and swing the back onto the pavement quickly
How to measure rotor thickness?
I use a micrometer the rotor should have minimum thickness stamped on the rotor is inches or millimeters
What is the minimum disc rotor thickness 03 ford escape?
The minimum thickness should be cast somewhere on the rotor.
What should be the age and thickness of rubber tree to tap it?
Ideally, seven years old, 22 inches thickness, about 50 inches above the budding point is where rubber should be tapped. Thickness of the tree is more important than age.
