answersLogoWhite

0


Best Answer

A tick in a lifter is likely caused by poor fuel. Using a higher octane fuel will often stop the knocking or ticking.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What to used to stop lifter tick in 1998 GMC Sierra 1500 with a 350 tbi?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How can you stop the door from sagging on a 1998 Chevrolet 1500?

You will have to replace the door hinges are pins.


The windshield wipers on your 1998 Sierra will stop and then restart How do you repair this?

replace the pulse board on wiper motor which is a black cover


How do you fix lifter that stick's when cold but stop's when warm on a 2004 Chevy vortex s10?

You can't fix a bad lifter, replace the bad lifter with a new one.


What would cause the fan motor to stop working on a 2006 GMC Sierra 1500?

Bad fan motor - Check to see if it is getting power Blown fuse Temperature sensor?


How do you stop lifter tap in your Nissan Quest?

Needs to remove the head for Reconditioned


How do you stop lifter ticking dodge 3.0?

only way to stop lifters from ticking is to replace the lifter. ticking or noise from lifters is caused by parts being worn most times whenthis happens the nlobe on the cam that the worn lifter is on, is also worn,so you have to decide if it is worth paying for both to be replaced


Why would a 1998 dodge ram 1500 speedometer and odometer stop working?

check speedometer cable for possible disconnection; it comes out of firewall and goes to transmission


What would make a 1993 GMC Sierra 1500 start overheating and make the heater stop working?

Not enough coolant, water pump and/or thermostat. Add fluid and check to see if there is a leak. If not it's your thermostat.


What to do in Sierra Vista?

stop ask dumb qestions


When did the middle ages stop?

In 1500


Will an after-market oxygen sensor on a 1998 gmc 1500 stop the check engine light from coming on if you cut the cats off?

only if it sends back the right voltage to the computer.


How do you stop tapping in a 2.5 jeep motor?

It depends on what's tapping. You may have a bad lifter or a valve problem.