what engine size
if they are the same engine then yes.
on the bottom of the oil pan
On my 1990 Cherokee it is on the drivers side underneath against the frame follow the lines
you need to take off both caliper bolts and remove the caliper from the carriage... most Mazda calipers will not pivot...
In my '95 cherokee, the blower motor resistor is under the glove box. I assume it's about the same on a 1990. I posted instructions (with pictures, so at least you'll know what you're looking for) for replacing it on www.timsjeepblog.com.
I'm pretty sure that takes a 7mm Allen key.
Use a "C" Clamp to fully retract the piston into the caliper body
I did my jetta brakes many times, but I dont recall the bolt lengths. Ensure you have adequate engagement into nut. The dealer can supply you with the proper bolt for about 4 bucks.
I am actually looking for a fan diode assembly for my friends 1990 Cherokee lardeo. The diode on the Laredo is located on the drivers side wiring harness near the front headlight. It is a red flat diode with three wires and looks much like a flat connector plug (it measures 1 1/4" long x 1/2" wide x 1/4" thick)
A T60 or T65.
look uner the rear of the right front wheelwell. You should see a plastic cover with pushpins. Remove it and you should have access to the antenna.
no it wont fit cause ive just changed a 1990 jeep Cherokee transmission it had a 1998 jeep grand Cherokee transmission in it it broke the fly wheel and burned the torque converter up
The original tire size for a 1990 Jeep Cherokee Laredo is P195/75R15. The tires are for 15 inch wheels for the vehicle.
1990 will require an OBD1 reader
Remove wheels re-install 2 lug bolts to hold rotor in place Loosen caliper mounting bolts (2) Remove 1 caliper bolt to allow caliper to swing without stressing brake line Remove front brake pad Use "c" clamp on rear brake pad to retract piston Remove rear pad Install new pads swing caliper back in place tighten mounting bolts (35 ft lbs) Install Wheel DO NOT MOVE CAR UNTIL BRAKES ARE PUMPED TO RESET PADS TO ROTOR
Grand - 1990 Legends of Sport 1-6 was released on: USA: 22 February 1990
Remove Wheels Remove caliper mounting bolts Slide caliper off rotor Slide rotor off hub
Remove wheels Re-install 2 lug nuts to hold rotor in place' Disconnect flexible brake line Remove 2 caliper mounting bolts Slide caliper off rotor
remove tire. remove caliper assembly, it is not necessary to disconnect brake hosses, and hang caliper out of the way. simply pull off old rotor and swap with new one. replace caliper assembly and tire.
A 1990 Jeep Cherokee does not have a reset switch. The fuel system is computer controlled. If not functioning properly there could be a fuse or sensor malfunction.