Brake Pads and Rotors
Mazda 6

What tools are needed to change the brakes on a 2004 Mazda 6?

202122

Top Answer
User Avatar
Wiki User
Answered
2011-09-13 14:33:49
2011-09-13 14:33:49

Metric combination wrenches, socket set,possibly metric Allen wrench set, jack stands and hydraulic jack. Get a Haynes manual also available at NAPA parts stores.I hope this helps.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions




Tools needed to replace front brakes 2002 Ford Focus?


what tools do i use to change the front brakes in my 2003 Pontiac grand prix


The brakes on the Villager are as straight forward as the brakes on a 1965 Mercury. Only normal brake tools are required.


To replace brakes effectively, you need to know what type of brakes you have. In general, you will need a jack, new brakes, a wrench and Allen wrenches.


there has to be a special tool .. the caliber needs to be turned while its being compressed. i used a pair of channel locks to turn the caliber while using a c clamp to compressing it good luck.. keep an eye on the fluid level..


First of all, Do you have any specialty brake tools? Ben


Probably basic hand tools and perhaps a brake spring tool. If you pick up a shop manual for the car and read their directions, you should get some idea what you'll need.


Drums are not a job for beginners. With the right tools & a manual you could do it.


The tools needed for an oil change tend to be common tools. A floor jack is needed to access the oil pan. A pan which is used to drain oil into. A wrench and socket set is used to remove and replace the oil cap.


first off are they disk brakes, (like the front one)? or drum brakes?


It depends greatly on the repair needed and the tools you have on hand in determining how long it takes to repair brakes and brake services. If you don't have that have a professional do it.




No tools needed, that 1997 Cadillac Deville doesn't have a timing belt.


14 mm wrench or socket--top bolt does not loosen--take out bottom bolt and snap out pads -- front and back of each wheel


the only tools need are a 17 inch socket a rachet a "C" clamp to push the piston back in.


To replace the brake pads on a 96 Grand Am, three tools will be needed. First, a C-Clamp, then a hex key to remove the caliper bolts, and a screwdriver to work the caliper free.



The question you ask is too involved for a proper answer. You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00


basic tools are all that are needed its a simple job. They are disc type brakes.If you can do the front, then you can do the rear.


Changing your own brakes can in fact, be done at home. It is relatively easy to do, and in most cases it takes only an hour to complete. No special tools are needed, just space, time, and a bit of know-how. Learning this skill will also avoid you from having to pay costly mechanic fees.



brake fluid.10 mm 11 mm , wd40, and a buddy to help ya



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.