A parallel circuit is an electrical circuit that has more than one current branch.
The correct name is a Short Circuit.
A short circuit is when the current in a circuit flows directly from the live/phase conductor to the neutral conductor without passing through a load. This is dangerous because the amount of current in a circuit is determined by the resistance/impedance (assuming constant voltage). The resistance of the conductor is very low and this allows large amounts of current to flow which should operate the circuits protective device (fuse). In the absence of a protective device the current will cause the conuctor toheat up first producing fumes from burning insulation and eventually seting on fire.
Some different types of circuits are:openclosedparallelseriesThere are two types of basic circuits, series and parallel.In series, current stays constant and voltage is divided amongst the resistors.In parallel the voltage stays constant, Every branch of the circuit gets the same voltage from the power supplier, but there is different current in every branch but current doesn't get lost. Current entering a junction(branches) must equal to current out of the junction. Iin =Iout.The third type could be the Series-Parallel Combination, which has some components wired in series and other components in parallel. Solving these circuits requires more complex analysis techniques. See related link.Another AnswerElectrical circuits are generally classified as being: (1) series, (2) parallel, (3) series-parallel, and (4) complex. The term, 'complex' is a category into which any circuit that doesn't fall into the first three categories, is placed.
Circuit loading In Canada the code rule is, there shall be not more that 12 outlets on any 2 wire branch circuit. Such outlets shall be considered to be rated at not more that 1 amp per outlet. Where the connected load is known, the number of outlets may exceed 12 providing the load current does not exceed 80 % of the rating of the over current device protecting the circuit.
That's what it's for. You send too much current through the fuse and it blows to keep the circuit from getting any more power.
All the components in a circuit have a potential effect on the total current used by the circuit. You have to be more specific to get a more precise answer.
A circuit that has more than one path for the current to flow is a parallel circuit. The circuit must have two or more paths to be considered parallel. A circuit that has only one current path through multiple components is a series circuit.
yes
its less then the total current
Voltage remains constant; current increases.
A circuit in which electricity only flows in one path is called a series circuit.
The current branches, so that part will go through one branch of the parallel circuit, and part through the other branch. (It is also possible to have more than 2 branches.) Then it joins again.
The rest of the lights in the system will remain illuminated. Except in that branch of the circuit. The parallel branch(s) get more current if the voltage potential remains the same.
You add up the currents in each branch. The current in each branch is just (voltage acrossd the parallel circuit)/(resistance of that branch) . ==================================== If you'd rather do it the more elegant way, then . . . -- Write down the reciprocal of the resistance of each branch. -- Add up the reciprocals. -- Take the reciprocal of the sum. The number you have now is the 'effective' resistance of the parallel circuit ... the single resistance that it looks like electrically. -- The total current through the parallel circuit is (voltage acrossd the parallel circuit)/(effective resistace of the parallel circuit) .
In a series circuit, all the current passes through the one circuit. Any break will totally remove power from all of the circuit.Parallel circuits have more than one branch where the current can flow. A broken wire will only affect one part, the rest of the circuit will still pass current.In a series circuit, all the current passes through the one circuit. Any break will totally remove power from all of the circuit.Parallel circuits have more than one branch where the current can flow. A broken wire will only affect one part, the rest of the circuit will still pass current.
Because there is only a single path in series circuit and many paths in parallel circuit.
The resistance of the electrical conductor, eg a wire, reduces the current which can flow in the circuit. The remaining current which does flow generates heat, representing the electrical energy which has been lost in overcoming the resistance.