how can transmission fluid git in the intake
You can check your automatic transmission fluid in your 1992 Chevy Cavalier with the transmission dipstick. The dipstick will have marks that indicate whether it is full or low one quart.
It will take an experience mechanic approximately 8 hours to replace the timing belt in your 1992 Chevy Corsica. The 1992 Chevy Corsica does not have each timing chain, it has a timing belt.
Can 1992 Corsica transmission fit in 1992 grand prix se both with a 3.1 motor and both are kick down?
The radiator drain on a 1992 Chevy Corsica is located on the bottom, left side of the radiator. It provides a quick and effective way to drain the radiator during maintenance.
You must REBUILD the transmission.
I have a 1992 Chevy G30. Takes 10 quarts if the torque converter is empty.
Your 1992 Toyota transmission will hold 12 quarts of transmission fluid, when it is empty. You can check the transmission fluid level with the dipstick.
You will need to drop the transmission pan and replace the gasket. While you're at it, replace the filter and clean the pan.
IN THE ALTERNATOR
typically in the valve cover.
The 1992 Chevrolet Corsica ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
You can use any SAE certified automatic transmission fluid in your 1992 Mitsubishi. You should never overfill your automatic transmission fluid.
Put the new serpentine belt on to your 1992 Chevy Corsica pulleys. Push the tensioner pulley to the left to tighten the serpentine belt.
Check your transmission fluid. This happened to me in my 1992 Chevy Silverado & it turns out I had a tranny fluid leak.
You add transmission fluid down the transmission dipstick hole.
Not unless the 1992 is 4x4.
on steering wheel colum,the turn switch works it
It is located on the drivers side of the car on the bottom of the radiator
That would be the 4L60E
Follow the hose from your wipers to the bottom of the washer fluid tank. It is at the bottom of the tank, if you can figure out which wire that it operates from you can just install a universal pump and put it inline