Mufflers and Tailpipes
Check Engine Light
Chrysler Cirrus
Honda Civic EX

What will cause the check engine light to come on and off on Chrysler cirrus 1999 lx1?

495051

Top Answer
User Avatar
Wiki User
Answered
2011-09-13 17:37:33
2011-09-13 17:37:33

On my 98 Cirrus, replaced the fuel cap and then disconnected the battery for 10 minutes and the check engine light turned off. My wifes Lexus had a similar problem. Sometimes a different brand of Gas will do the trick too.

^ I tried this today and it worked! Thanks so much =)

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The Chrysler Cirrus did not come out until 1995. You reset the check engine light with a scan tool or by unhooking the battery. If you have not repaired the cause of the code the light will come back on.

check the size of the engine, if it is the same it will fit

You can not disconnect the check engine light.

A flashing check engine light is an indication of a severe engine misfire.

You need a code reader to reset & plug into port.

You put the transmission fluid into the dipstick where you check it, do it with the engine on, and on a level suface

Could be just about anything without more information. Check your oil level first.

A fast flashing check engine light is an indication of a running issue that is causing severe emmisions and catalytic converter damage. The normal cause is a harsh misfire. If you have it checked for codes, it should tell you which cylinder is the problem.

go to an auto parts store most will put on computer for you for free

The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.

Start the engine and idle in park. Pull the dipstick, wipe off and reinsert. Pull again and read the level.

Idle speed on a 1998 Chrysler is computer controlled and is not adjustable. If idle speed is incorrect, you have a sensor, actuator, or mechanical failure. Places to start are, check for engine fault codes. Check for vacuum leaks.

My Cirrus wouldn't start with no check engine light either and it was not the battery because the radio, lights, power windows work. After taking to my mechanic he began checking the electrical system and found that the sparks plugs were not getting any power because the distributor was bad.

Check engine light on?? Not running on all cylinders?

THE CHECK ENGINE LIGHT IS ON FOR MANY REASONS, THE BEST THING THAT YOU CAN DO IS GO TO A PERCISION TUNE IN YOUR AREA TO HAVE THE PROBLEM FIXED.THERE ARE ABOUT 5 DIFFERENT THINGS IT COULD BE, POSSIBLY THE OXIGEN SENSOR IS BAD.THAT IS USUALY THE PROBLEM.

You use a scan tool after repairing the cause of the code.

After repairing the cause, you can reset with a scan tool or by unhooking the battery.

check your spark plugs they could fouling up or gummed up enough to spark for a while then as they heat up become worse. a lot of common problems with engine stalling can be directly related to plugs or coil etc.

The service engine soon, or check engine, light is reset with a scan tool after repairing the cause of the trouble codes.

After fixing the cause of the problem. you clear code with a scan tool, or by unhooking the battery.

You can clear the code with a scan tool or by unhooking the battery. If the cause is not repaired, the light will return.

You can use a scan tool or unhook the battery after repairing the cause of the fault.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.