If your grand am was running before you did all of this then chances are you may have installed the CKP(crank positioning sensor) incorrectly. There is a correct alignment and air gap. You need to get these specs. If this is set correctly then thee may be defective ignition parts. Make sure you have the correct spark plugs (Reach, Gap, etc.). If all checks out correctly then it is possible you have a defective module or new coils that you installed. Let me know if you need anythnig else.
"how do you change a throttle position sensor on a 1998 jeep grand Cherokee?" could someone without any experience do it?
The crankshaft position sensor in a 2002 Jeep Grand Cherokee 4.7 liter is located left of the starter. In order to remove the crankshaft position sensor the CKP mounting bolt will have to be removed first.
How do i fix the TPS pedal position sensor in a grand prix pontiac 2004.
The crankshaft position sensor is on the top driver side of the transmission bell housing.
The Pontiac Grand Prix was produced from the years 1962 to 2008. The throttle position sensor in a 3.8 V6 Pontiac Grand Prix is located on the butterfly spindle of the throttle body.
Behinf the power steering pump
Throttle position sensor out of range.
It is part of the EGR valve.
The camshaft position sensor on a 1998 Pontiac Grand Prix is located behind the rear bearing of the camshaft. It constantly monitors the rotation of the camshaft and relays this information to the computer.
on the harmonic balancer in the front of the motor it's a little window sensor
there isn't a crankshaft position sensor on a 3.8l motor in a 1999 Pontiac grand prix according to the manual
Yes, my grand am had that problem a week ago, changed out the sensor and it runs like a champ!
DOWN BY THE OIL FILTER EASY TO DO
It is in the distributor.
OBD 0068 indicates a fault in the MAP throttle position sensor.0068 indicates a fault in the MAP throttle position sensor.
The crankshaft position sensor on a 2005 dodge grand caravan is located on the top side of the bell housing.
The crankshaft position sensor is bolted to the bell housing of a 96 Grand Cherokee. It is at the top of the bell housing, just on the drivers side on a 4.0 L and on the passenger side on a V8.
Check the 2001 Grand Ams crank shaft position sensor first. If the sensor is bad then the engine will not get fire or start.
On the top of the bell housing. thats the crank position sensor the cam sensor in a 93 is fixed in the distributor to replace it you need a new distributor
Where is the throttle position sensor on a 1997 pontiac grand am 4 cyl.
1983 doesnt have a crankshaft position sensor. you have an ignition module located on the side of the distributor.
The camshaft position sensor for the 3.0L V-6 engine is located in the distributor. Good Luck!
Crankshaft position sensor mounting bolt.
The camshaft sensor on a 1993 Pontiac Grand Am is located behind the rear bearing cap. It detects the position of the camshaft as it rotates and relays this information to the computer.