answersLogoWhite

0


Best Answer

It most likely the fuell pump

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What would cause a 1987 Chevy S10 Tahoe Blazer to serge run fine for a while then serge again- It's not the fuel filter-After 4 months of working on it I suspect it might be a vacuum problem HELP?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you fix 1995 s10 blazer dash for not working?

If nothing on the dash (instrument cluster) is working, I would suspect the electrical plug in back is disconnected.


Why does your Chevy blazer blow hot air out of vents?

Control problem, blend door not working are the places to start


Why does your blazer quit running?

I would suspect fuel pump failure.


What causes 99 gmc suburban wipers to stop working when in use?

it may have a cracked circuit board, my blazer had the same problem


How can you repair a power seat in a 1996 Chevy Blazer that suddenly stopped working?

my Chevy blazer power seat on my 1996 Chevy blazer isn't working


How do you fix speedodometer Chevy S-10 Blazer?

If it is electronic (not cable driven) and both the speedometer and odometer are not working I would suspect the VSS (Vehicle Speed Sensor) is faulty. The VSS can be found on the tail end of the transmission. If only the speedometer doesn't work I would suspect the dash cluster has to be replaced with a new or good used one. Really need to know what year S10 Blazer you have.


How do you fix a Chevy Blazer starting problem?

trying to fix simular problem


What does dodge have to do with a blazer?

Dodge is listed in a totally different sub -category than Blazer. I think they problem is you not this site.


What would cause the back hatch to quit working on your 1995 blazer?

Either the arm on the actuator broke off (common problem) or the actuator itself burned out (which happens over time).


Why would the wipers on a 95 Blazer stop working and then maybe a little while later they will start working again?

It has a circuit bereaker in the motor which can be weak or the linkage and transmissions can cause unusual drag on the motor. Have it checked out, I had the same problem on a GMC wiper motor of similar vintage. Solved with adding a specific ground wire from the wiper motor houseing to the frame. I have a 1997 Blazer that had the same problem. There was a recall on the wiper circuit board that fixed the problem. You may want to try if the recall was for your year of truck also.Jeff


What would cause a 2000 Blazer not to change from ac to heat?

The most common problem causing a 2000 Blazer to stay on heat is a problem with the blend door. Check the blend door and its control circuit to fix the problem.


How do you fix 93 s10 blazer Transmission wont shift into 3 or OD speedo gauge not working?

93 tranny is electronic if your speedo isn't working it won't shift into 3 or OD. Your speed sensor is more than likely the problem.