accelerator pump inside the carburator
if it runs fine until you push the gas pedal the accelerator pump may be bad if it has a carb on it.
Your 1983 Chevy S10 Blazer might stall when the accelerator pedal is depressed because of a clogged or dirty fuel filter. Gas that is mixed with water or condensation from the tank can also cause this issue.
Have your ball joints checked out.
bottom engine mount nut snaped
Yes, a broken or disconnected accelerator cable is the likely cause for the accelerator pedal to quit working. The car will still run fine but will not be able to accelerate past idle.
If it's a clunk sound, check universal joint bearings and drive shaft bolts. Otherwise please describe noise.
A defective EGR Valve will cause hesitation on acceleration.
your car being broke get it checked out
Letting a cord slide quickly through your hands may cause what is called a rope burn.
My 89 B2200 does this. Its like there is a dead spot in the acceleration. It is because the accelerator pump is leaking.
The cruise control, since it affects the accelerator, can also cause a change in velocity.
Check the inside of the distributor cap for damage. If nothing is found, continue as with a normal "cranks no-start" diagnosis.
Weak fuel pump? Fuel filter? Air filter? Sloppy timing chain Timing not adjusted properly Vacuum advance not working? Accelerator pump in carb not working?
fuel blockage maybe.
the cause was letting them rebelish and trust god
accelerator pedal could have some strain in it and might be leaking petrol into the carburetor
Letting off the throttle control
When you press the accelerator and brake together in a motor car, the engine will rev, but the brake will stop it from moving. Doing this repeatedly can cause the vehicle damage.
Could be a bad throttle body
The brake pedal and the accelerator pedal can cause a change in speed.