answersLogoWhite

0


Best Answer
all 4 turnsignals flashTwo things to look into. Most likely is your hazard switch is failing/shorted inside. Second, if problem started when bulbs were replaced take the bulbs back out and look into the socket, make certain that if the socket has two connectors in the bottom that a dual filament bulb (ie with two contacts on the bottom of the bulb) is what you plug into it. Plugging in a single filament bulb into a dual filament socket shorts the two contacts together causing weird light behaviour.

Hope this helps

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What would cause a vehicles turn signals to turn on both turn signals at the same time like hazard lights?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why doesn't the turn signal lights turn on but the hazard lights work?

If the turn signals on a car works but the hazard lights do not there may be a problem with the flasher switch. The flasher is located in the steering column, and a damaged unit can cause the lights to stop working.


What would cause the hazard signals and the turn signals not to work on an Audi A4 1996 1.8T?

Flasher is faulty.


What is the most likely cause of blown hazard lights fuse on a 199 Dodge Caravan?

Water is commonly getting into the hazard light systems


What would cause the turn signals not to work but the emergency lights to function properly when the bulbs and fuses all seem okay?

Possibility you may have a bad hazard flasher unit or turn signal switch. The cheapest route is to try to replace the hazard flasher unit as your first solution to the problem. Hazard flasher units should only cost you under $10 .


Would a 1998 Volvo v70 hazard flasher switch cause the turn signals to stay illuminated?

Yes. The relay that controls the turn signals is built in the switch.


What would cause the hazard lights to come on on their own after the car is turned off?

The light control module could be the cause of hazard lights coming on after the car is turned off. There could be a problem that has caused this module to become wet and it is now not working correctly.


Xterra 2002 why do your turning signals not work but your hazar lights work?

be cause your bulb is blown out


What would cause the turn signal lights on a 1992 Explorer to light up but not flash The emergency flashers work but the turn signals will not flash?

either a bulb or the signal flasher relay located on the fuse panel usually opposite the hazard flasher relay


What happened when your 1992 Accord was hit on the front driver side to cause none of the turn signals to work while hazard and driving lights work power is shown to all lights and it is not a fuse?

It sounds like the ground for the parking/turn signal circuit is bad on the damaged side. You mentioned sufficient power to all lights, I assume this applies to the parking/turn signals too. If this is not the case check the main fuse box for disconnected, pulled-out connections. Hope this helps,


What would cause all your lights and turn signals not to work only at night time?

A dead battery


What would cause my Turn signals and brake lights do not work on a 2000 Chevy cavalier?

have you checked your fuses?


What will cause brake lights not to work or running lights do have turn signals?

A blown bulb. Check fuses and then start replacing the bulbs one by one.