on my 94 Z-71, the stop lamp switch was bad, on the lower steering column, and this switch is what gives the CC (cruise control) the signal to disengage. So in effect, when you depress the brake pedal, the CC assumes u are slowing down on an incline or some other natural deccelerant, and engages the accelerate function to compensate. check to see that your stop lamps are functioning, if not, this COULD be your problem, or something in this line of the system.
cruise would work but if i push to accelerate it would disengage an truck only after restarting would it work again. Now it does'nt work at all. Any suggestions?
no it does not.unless you disengage with the brakes,not the control button
No , absolutely not ( if you hit a puddle , which will slow the car down , the cruise control willtry to accelerate the car to maintain the set speed )It's not recommended to use the cruise control in the rain. Normally, you use the cruise control on the highways. When it's raining you need complete control on the car and be fully alert.( NO ) if you hit a puddle that slows the car down then the cruise control will accelerate the carbetter not it could cause the car to accelerate at the wrong time and cause loss of control
Check in your vehicle's owner's manual for reccomendation's regarding the cruise control. I have seen manual's that say not to accelerate up hill's with the cruise control.
To use the cruise control on the PT Cruiser, turn the cruise control on in the steering wheel. Accelerate to the desired speed and push in the end of the left turn signal knob. The cruise control should then control the speed. To take the car out of cruise control, a person can tap the brake.
Maybe the cruise control is set to the on position unknowingly.
Down on the brake pedal. It will also disengage the cruise control.
Most cruise controls will disengage if the gas pedal has to go too far or if the speed drops too much.
VERY bad idea to do this.no it guves you less control and if you beging to skidd your cruise control will tell your car to accelerate and you will take off like a plane
yes.tcc will not work corect or cruise control
the same way it accelerates anytime its on cruise control. It's electronically moving the gas pedal to make up for the speed lost by cornering.
you have to be above 25mph. there is a button by the light dimmer that has to pressed to turn on the cruise system then move the stalk control down to set current speed. You can then increase speed by moving the control up, decrease by moving thecontrol down and disengage by pulling towards you.Moving the control up again will return you to the previously set speed providing you are over 25mph. If you cannot get the cruise to work and the light is 'on' on the master switch check that the switches on the clutch and brake (for a manual car, brake only for auto) have not moved away from there mounts on the pedal. Mine had slipped back so they did not contact the brake pedal when it was fully released. Touching the brake or clutch pedal will disengage the system.
bad connection at set button on collumn
Make sure you have the main cruise control button depressed. You will then see a display light indiciating "Cruise Control". After that, just use the normal buttons to set, accelerate, and coast. BEWARE, though. The cruise control button for our 2004 Accord stopped letting me keep it in the depressed position, and I can't keep my cruise control on now. Will let you know once the mechanic takes a look at it.
tap the brake pedal there is also a cruise control wand immediately behind the steering wheel at approximately the 10'o'clock position. You can control the cruise control with this stalk. Pushing it forward while you are at a steady speed will lock the speed in. Pushing the stalk forward will disengage CC. Pushing it down will slowly reduce the speed. Pulling it back will slowly raise the speed. But touching the brake should always completely disengage the system.
Its at the top of the clutch pedal there is a cruise control switch disengage switch at the bottom and the one above that is the clutch inhibitor switch.
If the car is going up an incline, it will attempt to keep the speed constant with the setting of the cruise control. When that process is satisfied, the car may decelerate a bit to keep the same speed. If the car continually decelerates whe using the cruise control. stop using the cruise and have it checked. It id very dangerous to use the cruise control that is not operating properly. It could cause the car to accelerate unexpectedly.
have you checked to make shure that hte cruise control isn't on if your vehicle has one?
Cruise control is an accessory.
It is possible to convert a car without cruise control to have cruise control. Many auto parts stores sell kits which will install cruise control in a vehicle.
There are several ways to fix the cruise control on your Mercedes-Benz depending on the problem with the cruise control. Make sure the fuse for the cruise control is not blown.
2004 sebring convertable cruise control not working - what to do?
My E150 van 1994 5.8L has intermittent misses at idle and cruise. Cruise control & Idle air control doesn't work? Stalls when trying to accelerate from a dead stop (traffic light, etc.) Can you give me a more detailed explanation for code 212?
There is no isolated fuse for the cruise control. It all runs off the 20A gauges fuse. If you are having trouble with the cruise control I would check the Cruise Control Module or the Cruise control Servo. What symptom is occurring?
If the cruise control on your 1987 300ZX does not work, you might have an issue with the cruise control fuse or wiring. You could also have a problem with the switch that turns the cruise control on and off.