answersLogoWhite

0


Best Answer

Excessive blow by from an engine position sensor. You would check this by verifying crankcase pressure and making sure the engine is in proper time and valves properly adjusted.

User Avatar

Wiki User

โˆ™ 2013-01-25 10:19:17
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: What would cause low power in 5.9l under a load?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What would be the most likely cause of low power on cummins N14 series engine under load?

The most likely cause of low-power, when under load, in your Cummins N14 diesel engine is a lack of fuel. The problem can also be a lack of air flow.


A Cummins N-14 series has low power under load what would cause this?

This would be only caused by Excessive blow by from the engine position sensor.


When under a load what would be the most likely cause of a low power condition on a cummins 5.9l isb diesel engine?

Fuel or air.


Why power generated with under frequency is harmful to the load?

Why power generated with under frequency is harmful to the load?Read more: Why_power_generated_with_under_frequency_is_harmful_to_the_load


What causes Low power under load cummins 5.9L?

There are several things that can cause low oil pressure on your comments 5.9 liter diesel engine. The most common cause of low oil pressure, when under load, is a faulty turbo.


What would cause your 2002 silverado 4.8 to run rough under load?

What might cause your 2002 Silverado 4.8 to run rough under a load could be clogged fuel injectors or a clogged fuel filter. It might also run rough under a load because of a transmission sensor issue.


What would cause a low power condition on a Cummins 5.9L ISB engine when under load?

A few things can cause this problem, stuck open wastegate, excessive blow-by or an air leak on one of your intake hoses.


How much power is lost in a power distribution transformer under no load?

major component of power loss in a transformer is secondary resistance.when transformer is operated under no load,no current flows through the secondary.so under no load conditions transformer has just very small megnetic losses.


What pieces of information are needed before selecting a power supply?

The main piece of information needed is the load wattage or amperage that will be connected to the power supply. Once this is known the power supply of a greater size that the load should be chosen. Also with this information the size of the wires can be calculated from the power supply to the load. Too small a wire will create a voltage drop at the load end of the circuit. This will cause under performance of the load.


What is the cause for leading power factor?

If the load is capactive then power factor tends to be leading


What would cause vacuum from the exhaust pipe?

Clogged catalytic converter or y-pipe. I had the same problem. Also, if you smell rotten eggs or have lack of power under load as symptoms as well, I can almost guarentee it.


Can reactive power be used to power a bulb?

The 'type' of power is determined by the load. If the load is resistive (e.g. a lamp) then the rate at which it consumes energy is termed 'true power', expressed in watts.You seem to be under the impression that reactive power is 'pushed out' into a load. This is quite false; the loaddetermines the power.

People also asked