It could be a bad cylinder, bad springs, bad emergency brake, or could need to be adjusted.
Brakes shoes are those parts that are located on the back of the brakes to help keep the drums and rotors in place. Some cars has wheel cylinders and others have brake shoes.
Warped brake rotors/drums.
Brake drums can not be cut. The shoes inside can be replaced.Only disc brakes(rotors) can cut.
brake drums are located where
Check that the hand brake is not applied. Check the conditions of your brakes like the drums check if there any grooves or are hot to the touch. If you feel any grooves replaces brakes and lathe the drums or replace the drums aswell.
There are no calipers used with brake drums. Brake drums work with curved brake pads pressing against the inside circular surface of the drum when the brakes are applied. These pads are held in place and pushed by a spring and lever assembly that is mounted to a steel plate attached to the wheel or axle of the car. This plate does not move. Calipers are used with disc brakes to hold the brake pads on both sides of the disc brake and to apply them against the disc when the brakes are applied.
rear brake drums or rotors are out of round.
at the rear brakes. remove wheels, & brake drums, adjust rear brakes to specs, and the E-brake will automatically be adjusted.
The brake pads or brake shoes are worn and rubbing against the rotor or drum, Disc brakes use brake pads and brake drums use brake shoes. Need to get them replaced before they cause too much damage or you will wind up with repairs or replacement of the rotors or drums also.
Yes , on the back wheels ( disc brakes on the front )
what is the question about the back brakes?? they are usually drums
you might have to bring it to a brake lave to size up the rotors and brake drums.