Auto Parts and Repairs
Car Electronics and Lights
Headlights Tail and Brake Lights
Ford Ranger XLT

What would cause the brake light to stay on unless the fuse is removed?

424344

Top Answer
User Avatar
Wiki User
2004-10-09 19:03:58
2004-10-09 19:03:58

most probably because the brake light switch is stuck in the "on' position. The switch is most probably right under the dash on the drivers side connected to the brakes swing arm pedal.when you step on the brake,the arm moves and set the brake light on.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The light assy has to be removed and the bulbs removed from the back.

User Avatar

The 1993 Ford Probe rear brake light lens cannot be removed. The tail light are a complete seal light. The light bulb's can be removed from the rear of the light assembly.

User Avatar

A blown fuse is always a sign of excessive current flow. In this case, it's probably caused by a short circuit in the brake light wiring.

User Avatar

To replace the brake light bulb you need to remove the whole light assembly. Once removed the change is simple.

User Avatar

The brake light bulbs ar removed from the rear of the light assy . Take it off of the body.

User Avatar

You can remove the ABS and brake light, from your Oldsmobile Alero, by removing the dash cover. The light retaining nut must be removed. The light will come out.

User Avatar

Brake light switch either out of adjustment or defective Should be located at upper end of brake pedal under dash

User Avatar

To replace the brake light on a 2001 Dodge Durango the light lens must be removed. It is held on by a clip on one side and a hinge on another. It opens like a door to access the brake light housing.

User Avatar

The brake fluid may be low. If it is low, it is a sign that you are in need of brake work soon.

User Avatar

The brake light switch is under the dash, and whenever the brake pedal is touched the brake light comes on. If the switch has failed or is out of adjustment it will leave the brake light on.

User Avatar

The light assy has to be removed to take the bulbs out.

User Avatar

The most probable cause is that the brake light switch is out of adjustment.

User Avatar

A brake fluid leak in the brake system, LOW BRAKE FLUID.

User Avatar

More than likely it is the brake light switch that is attached to the brake pedal.

User Avatar

The most likely cause is low-brake fluid.

User Avatar

This is usually cause by a stuck brake light switch on the brake pedal. Replace it.

User Avatar

The " BRAKE ' light in your dash indicates that either your parking brake is on or the BRAKE FLUID LEVEL in the brake master cylinder in your engine compartment IS LOW

User Avatar

You can disconnect your emergency brake light removing the emergency brake cable. The emergency brake cable can be removed by turning the swivel nuts to the left, on each end of the cable.

User Avatar

adgust the brake light switch at the brake pedel under the dash

User Avatar

Friend says cause your brake light is out., although im not sure that i can trust him.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.