Check the wiring and socket to the high beam light. Mine was bad on a 96 and after replacing it mine worked.
did you ever figure out what was the matter with the car....? curious....as i have a 2000 that the daytimes go out on ...and do not have any high beams.....thanks
My did the same, you have to replace the regular light bulb on the drivers side, it should work after that. Is your service light (on your dashboard) on?
I have changed the driver's side bulb and checked all of the fuses,now the passenger side stays on hibeam only, nothing seems to work. And now the truck will not enguage into gear at all? any advice?
the bulb is probably blown there like a headlight bulb low beam hibeam so if its blown it will just be illuminated and not flash
you start by removing the chromed Ring which is held in place by 1 screw at the top center; then you remove the Inner screws which hold the black ring to the headlamp Bucket, which holds the headlamp in place; WARNING: do not confuse these screws with the headlight Aim Adjustment screws which you can identify by a white plastic spacer and Spring behind them. do not touch those. Once the black ring is loosened and removed, the headlamp will tend to fall off, so keep your hand in front of the glass lamp. Pull the glass headlamp out from the Bucket, then disconnect the Electrical Plug from the rear of the headlamp, get the new replacement, re-connect the Plg to it, then reassemble both rings in reverse. this applies to all 4 headlamps. Same procedure and warnings apply.
where is the daytime running light relay located on a 2002 chevy cavalier
The daytime running lights on the 2006 Corolla are a safety feature. They are designed to make it easier for other drivers to see the vehicle.
Bulbs burned out or fuse and or relay popped
Inner fender, drivers side.
daytime running light module under drivers side dash
drivers side behind the fuse box in the inside of the fender wall
The Daytime Running light module on the 2001 Ford Explorer is located on the drivers side of the explorer just behind the bumper. It is a black box with fins on it and an oval shaped connector..
Sounds like it might be a bad ground
Behind the front drivers side bumper reinforcment bar.
under the hood,drivers side in the electrical control box
The day time running light module is located behind the dashboard. The module, can be found on the drivers side of the dashboard.
The purpose for police not wanting, or disabling, the DRL's is that they do not want to have their visibility increased to other drivers.
It may not have daytime running lights.
2004 CAVALIER-FUSE COMPARTMENT ON DRIVER'S SIDE INSTRUMENT PANEL- 5 PRONG RELAY PART # 12193602 2004 CAVALIER-FUSE COMPARTMENT ON DRIVER'S SIDE INSTRUMENT PANEL- 5 PRONG RELAY PART # 12193602
how so you turn on the daytime running lights on a 99 suburban
don't believe they had daytime running lights in 1991 topaz
How to change the daytime running lamp on 2008 GMC Acadia
under the hood on the drivers side behind the fuse box .attached vertically to the inner fender
my 05' cavalier has a bad alternator problem its charging the battery a little bit then stops and the little power my battery has is drained by the end of the night. I replaced the alternator twice and the battery but still no difference.
I just had the same problem and replaced the daytime running lamp module. Ford part # xl2z-15a272-ab. This part is located behind the drivers side head light and gotten to thru the wheel well.
there is a relay under the hood that should disconnect the daytime running lights
This car does not have daytime running lights.