Headlights Tail and Brake Lights
Saturn (car)
Chevy Suburban
Jeep Wrangler Sport

What would cause the dome light map lights and power locks to all stop working on a 97 SL2?


Top Answer
User Avatar
Wiki User
2005-09-09 19:32:27
2005-09-09 19:32:27

Check fuses first than wiring to all doors for pinched wires that may be contacting each other.


Related Questions

wheel locks up and abs light come on because abs not working on that wheel lights go dim because alternator not working completely

door open light is on, locks and mirrors will not work

yes, it is a fuse it will be labled int. lights/ horn on the fuse box

if your cig light is not working as well, the fuse is in the glove box top and last in that row, had the same problom.

A blown fuse or a damaged computer would cause the turn signals, interior lights, and door locks not to work in the Mazda 3. The fuses are located under the dash on the driver's side of the car.

You can use "Scotch locks" on the tailights, and stop lights - trace them from the rear light fixture

Wipers, door locks, lights, alarm if equippedWipers, door locks, lights, alarm if equipped

Depends of course on the vehicle but there are different fuses for the locks than the lights. My suggestion is to open the door so the lights are on and pull relays from the fuse block under the hood till they go out. This should disable both auto locks and dome lights.

Fuse number 23 in the passenger compartment box is blown. It caused the following devices to stop working: Door lock switches (but not the locks), Interior lights, radio lights, A/C climate control, overhead console quit.

If the room fuse is blown out; the radio will not work, the power locks will not work properly, the vanity mirror lights will not work, the interior lights and trunk light will not turn on.

bad ground on chassis. do the lights seem dim when you apply the brakes?

If you will look there are some metal contact on usually the right rear door, it looks like brass or copper connection. These contacts will get corrosion on them and quit working, if you will use some steel wool or light sand paper to knock off the dark color they will probably start working again.

What you probably need to do is to check you battery because i have a dodge 2004 also and my locks did the same thing so i just replaced my battery and the locks started working again.

I got mine replaced by my extended warranty due to my dash lights not working. The multiplex control on the driver side kick panel controls your power locks. If you are having problems with your power locks not working and it's not a blown fuse, then replace the multiplex.

If the power door locks quit working on a 1979 Corvette, it is due to broken pigtail switches. With age and use, the pigtails break and leaves the power door locks inoperable.

wipers,headlights,speedometer,door locks,air conditioner,electric mirrors, stopped working

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.