Ford Explorer
Ford Bronco XLT
Geometry

What would cause your 1992 Explorer to have its fuel economy cut in half?

161718

Top Answer
User Avatar
Wiki User
2005-11-24 01:51:42
2005-11-24 01:51:42

Do you have a check engine light? If not, then first a good tune up with a fuel filter. Also, have the clutch fan checked. If it stays "locked in" then that also will hurt.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

No, the door on a 1998 Ford Explorer will not fit a 1992 Ford Explorer.

User Avatar

No because most transmissons are unique and the 1996 is older than the 1992,now if u was tryin to put a 1992 into a 1996 it would work

User Avatar

How do you replace evaporator on a 1992 ford explorer?"

User Avatar

Starting with the 1995 model year of the Ford Explorer the AUTOMATIC transmission was ELECTRONICALLY controlled ( so the answer would be no )

User Avatar

R 12 was used when the 1992 Explorer came from the factory

User Avatar

Type your answer here... How do you remove ignition switch from 1992 ford explorer?

User Avatar

it can be a couple of things such as hubs,driveshaft,u joints or fluid levels

User Avatar

The 1992 Ford Explorer uses an A4LD automatic transmission

User Avatar

On a 1992 Ford Explorer : The firewall is the metal wall that divides the engine compartment from the passenger compartment

User Avatar

On a 1992 Ford Explorer : The voltage regulator is mounted on the back of the alternator

User Avatar

Motorcraft BXT - 65 - 650 is Fords " top of the line " battery for a 1992 Explorer

User Avatar

I believe the 1992 Ford Explorer 4 door holds 19.3 U.S. gallons

User Avatar

I believe the 1992 Ford Explorer 4 door holds 19.3 U.S. gallons

User Avatar

Economy Car Rentals was created in 1992.

User Avatar

specs on how to replace a heatercore on a 1993 ford explorer

User Avatar

ford parts . com ( no spaces ) shows the ( Motorcraft FA-1043 ) engine air filter for the 1992 Ford Explorer

User Avatar

The curb weigh of the 1992 Ford Explorer XLT 4-door with 4-wheel drive is 4,012 pounds. The Ford Motor Company has been producing the Explorer since 1990.

User Avatar

I believe that is in the fuse panel

User Avatar

The brass float on my son's 1994 explorer leaked and had fuel in it causing to show empty all the time. We had to pull the fuel pump/sending unit out of the gas tank. Had to remove the gas tank to do this. ------------------------------------------------------------------------------------------------------------ A 1992 Ford Explorer has a 15 amp fuse in location # 17 for the fuel gauge according to my Chilton repair manual (Helpfull)

User Avatar

A 1992 Ford Explorer was not designed to have third row seating The first model year that third row seating was available was the 2002

User Avatar

The 1992 Ford Explorer is a 4.0 liter OHV engine , in 1999 ( depending on which model and trim you have ) the 4.0 L OHV engine and the 4.0 L - SOHC - engine was used


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.