dirty trans fluid might be the cause. have it changed, but not flushd
The overdrive transmission that a 1992 Chevrolet C3500 would have is a 4L80E. It is a series of automatic transmissions from General Motors.
Try your tcc solenoid on the transmission
if you have overdrive in that car it means that your about to go into overdrive
the overdrive sencer
what would transmission not to shift in to overdrive
If the overdrive switch is turned off then the car will not go into overdrive. As it is not in overdrive, then it will not downshift out of overdrive as it normally would. It also will not shift to 3rd gear above a certain factory preset speed. Turn th overdrive on and see if it operates normally.
There are several things that can cause your 2000 Chevrolet to backfire and die. The most common cause is a plugged catalytic converter.
it has a malfuction so its setting a code
something is wrong in the transmission. It will have to be diagnosed. You probably have a bad shift solenoid in the tranny.
A malfunction has been detected - get it checked out
It could be out of gas.
The most likely cause is the turn signal flasher.
typically this means the ignition module is bad
Your transmission might automatically shift out of overdrive while driving on the interstate because of low transmission fluid. This issue might also occur because of a bad transmission sensor or overdrive sensor.
If you are city driving, and stopping at many lights. The tranny might be shifting into overdrive constantly for just a few seconds before you have to stop again, which would cause excessive wear on an expensive transmission. Personally, in this situation I would disengage the overdrive.
First, check fluid, if sufficient then check sensor that communicates with the transmission.
100-300 or so depending on specifics
The clutch might not be completely disengaging.
The most probable answer is that you have a bad flasher.
after replacing the stearing colum what would cause it not to start. You may have disconnected the ignition switch.
The Overdrive Light flashing indicates an internal transmission problem which could be caused by anthiny inside the transmission. Most likely the transmission would have to be removed and taken apart to find the problem.