answersLogoWhite

0


Best Answer

This is something that needs to be diagnosed but It is most likely a bad ground to to keyless entry control module, a faulty instrument fuse panel or a pinched wire in one of the front doors. Difficult to give an answer as could be a number of things @@@ I had the same issue on my 97 SC2 while I was at the range in Florida. Turns out, all the dealership in Saint Pete did was change the battery, problem solved. But as the last person mentioned, it could be a number of different things@@@

User Avatar

Wiki User

โˆ™ 2008-02-08 05:30:46
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: What would cause your 1996 Saturn sl2 door locks to cycle open and close?
Write your answer...
Submit
Related questions

What do you need to convert to power locks on a 96 Saturn sl1?

PCM, Relays, Power locks, wiring


What can cause a Saturn sl1 door locks not to work and also to lock while you are driving by themselves?

The door lock relay is the culprit. where it is I have not a clue so far.


How do you reset the remote key when you replace the batteries on a 2003 silverado?

If you have one remote that is working you can hold down the lock and unlock buttons at the same time until you here the locks cycle open and close, this puts the body control module in the learning mode then you hold the same buttons down on the remote that does not work until the locks cycle again and that should do it.


What cause a compressor to stuck?

Locks up


1995 Nissan door locks and security system malfunctioning?

I have a 2001 Nissan quest,recently my door locks are malfunction,when I pull the door in it locks,when key in ignition it locks,what cause this problem?


How do you convert regular locks into power locks on a Saturn vue 2003?

you need to put a solenoid in-line with the linkage that operates your vertical or horizontal locking button or flip lock.


How do the locks work on a canal?

The locks would close around the ship or barge and water would lift. Then the lock would open for the ship to continue.


What cause engine locks?

running with out engine oil


How do you program the remote on a 2001 Toyota Avalon?

Here is a way for programming a remote for a 2000 Avalon. This method should work for 2001 Avalon also. Key out Driver door open and unlocked Insert key into ignition and pull out Lock then unlock the power locks from the master switch 5 times Close and then open the driver's door Lock then unlock the power locks from the master switch 5 times Insert the key into the ignition and turn to ON then OFF, then remove key Locks should cycle - If they don't repeat Press both the LOCK and UNLOCK buttons on the remote simultaneously for 1 second Immediately after letting go of the two buttons, press the LOCK button for 2 seconds The locks should then cycle once. If they cycle twice, try again. Close the driver door


How do you program a keyless remote for a 1996 Chevrolet suburban?

Using the OBD2 connector under the dash. You need to check the connector, it is numbered 1-8 on the top and 9-16 on the bottom. You will need to jump #4 and #8 pin with a paperclip or wire. The locks will cycle off and on once it is jumped. When the locks cycle, press the lock and unlock buttons on the key fob and hold until locks cycle again. (some GM vehicles you need to turn the key on for this, not usually on the suburban.) Once the locks cycle again, it should be programmed. You will need to do this for each fob.


Where is the fuse for the electric door locks on a 98 Saturn SC2?

please I have a 1998 Saturn coupe SC 2 both power door locks out the same time 3 weeks ago. Is the fuse box for door locks under the hood or in the auto. next question could it be the switch on the door behind the lock itself, but why both out the same time? thank you very much.


Which process locks phosphorus in a long term cycle?

organic materials buried at the bottom of the oceans


Programming instructions Lincoln navigator key fob?

1. Close all doors and then open drivers door and press the UNLOCK button on drivers door panel while door is open and insert key in ignition. 2. Turn ignition from OFF to RUN 8 times within 10 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm programming mode. 3. Within 20 seconds press any button on first keyless remote. Door locks will cycle to confirm programming. 4. Within 20 seconds, press any button on second keyless remote. Door locks will cycle again to confirm programming. 5. Turn ignition to OFF. Locks will again cycle to indicate end of programming mode.


What is the cause of my power door locks and radio volume not to work?

The cause of your power doors and locks and radio volume not to work could be a blown fuse. Locate the proper fuse to ensure it has not blown.


How do you program a 1998 Ford Escort remote?

1. Turn ignition from OFF to RUN 8 times within 10 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm programming mode. 2. Within 20 seconds press any button on first keyless remote. Door locks will cycle to confirm programming. 3. Within 20 seconds, press any button on second keyless remote. Door locks will cycle again to confirm programming. 4. Turn ignition to OFF. Locks will again cycle to indicate end of programming mode.


Does the 2002 Saturn SL1 have power locks?

Hmm, a 2002 i would say yes, well atleast it might be an option, but almost every new car from 2000 and up come standard with power locks.


Why Car locks and unlocks by itself?

cause it's cool like that!


How do you program the remote transmitter for the doors on a Toyota 4Runner?

1. Start with the following conditions: you are in the vehicle a. Key is out of the ignition b. Drive door is open ( all other doors are closed) c. Driver door is unlocked (other door locks don't matter) 2. Insert the key into the ignition (don't turn it) and pull it out. 3. Perform these steps within 40 seconds: a. Cycle the power locks 5 times. Use an even pace and try to go relatively fast. b. Close, then open the drivers door. 4. Perform these steps within 40 seconds: a. Cycle the power locks 5 times (same as before). b. Turn the ignition to ON then back to OFF. c. Turn the ignition to ON then back to OFF. d. Remove the key from the ignition. 5. Within 3 seconds, the power door locks should cycle (automatically) indicating successful entry into programming mode. Return to step 1 if the locks do not cycle at this point. 6. Perform these steps within 40 seconds: a. Press the LOCK and UNLOCK buttons on the transmitter simultaneously for 1 second. b. Immediately after letting go of the lock and unlock buttons, press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should cycle ( LOCK then UNLOCK) once-- indicating successful programming. If the door locks don't cycle, or cycle twice. Repeat steps 6a and 6b--this remote has not been accepted. c. Repeat steps 6a and 6b for EACH transmitter that will operate the vehicle. Including any old transmitters. 7. Close the driver door.


How does one activate door remote transmitter for 4Runner?

1. Start with the following conditions: you are in the vehicle a. Key is out of the ignition b. Drive door is open ( all other doors are closed) c. Driver door is unlocked (other door locks don't matter) 2. Insert the key into the ignition (don't turn it) and pull it out. 3. Perform these steps within 40 seconds: a. Cycle the power locks 5 times. Use an even pace and try to go relatively fast. b. Close, then open the drivers door. 4. Perform these steps within 40 seconds: a. Cycle the power locks 5 times (same as before). b. Turn the ignition to ON then back to OFF. c. Turn the ignition to ON then back to OFF. d. Remove the key from the ignition. 5. Within 3 seconds, the power door locks should cycle (automatically) indicating successful entry into programming mode. Return to step 1 if the locks do not cycle at this point. 6. Perform these steps within 40 seconds: a. Press the LOCK and UNLOCK buttons on the transmitter simultaneously for 1 second. b. Immediately after letting go of the lock and unlock buttons, press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should cycle ( LOCK then UNLOCK) once-- indicating successful programming. If the door locks don't cycle, or cycle twice. Repeat steps 6a and 6b--this remote has not been accepted. c. Repeat steps 6a and 6b for EACH transmitter that will operate the vehicle. Including any old transmitters. 7. Close the driver door. (from a Toyota forum)


How do get the automatic locks in a 1997 Dodge Intrepid to turn off?

The Automatic Door Locks can be enabled or disabled by performing the following procedure: # Close all doors and place key in the ignition. # Cycle the ignition switch On and Off 4 times ending up in the Off position. # Depress the power lock switch. # A single chime will indicate the completion of the programing.


Where is the lighter fuse on a 1996 Saturn SL2 It isn't labeled?

The cigar lighter actually uses the locks fuse underneath the dash.


Do you get a free hair cut when you donate your hair to locks of love?

No, they don't. Some programs may, but for Locks of Love, you just donate it for the good cause.


How do you program a keyless entry fo your Mazda tribute?

Using the drivers side switch, cycle the power door locks LOCK, UNLOCK, LOCK, UNLOCK. Cycle the ignition from OFF to RUN eight times within 10 seconds, ending in the run position. The power door locks should cycle to indicate program mode, vehicle is ready to accept remotes. Press any button on the remote, once again the locks will cycle to indicate a successful program. Turn the ignition off to exit the program mode.


How do you fix sticky electric locks on a 2001 ford excursion that will not always fully open or close?

please let me know - i have a 2000 and the locks wiggle but dont work correctly .


Why are the power locks on a 96 Saturn locking and unlocking constantly and draining the battery can this be fixed with a fuse or by disconnecting the locks?

I had the same thing happen to me yesterday. Today the car won't start at all and the battery is fine. Locks continue to lock and unlock as if the car was possessed. Help would be most appreciated!