answersLogoWhite

0


Top Answer
User Avatar
Wiki User
Answered 2011-09-13 17:56:12

almost anything go to your local parts stores until you find one that reads codes for free and have them check it I'm lucky in Chicago suburbs all but one or two read codes for you

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still have questions?

Related Questions

Where is the knock sensor on a 1989 Chevrolet Caprice?

it is located on the side of the engine block.


Where is the crankshaft sensor on a 1989 Chevy caprice 350 engine?

There is NOT 1. not on that year.


Where is the knock sensor located on 1989 Chevy Caprice?

It is located on the side of the Engine block.


Where is the Engine Coolant Temperature Sensor located at on the engine of a 1996 Chevy Caprice LT1?

Bottom right of the water pump. Dead center of the engine in the front.


Where is coolant temperature sensor on 86 caprice?

Could be the the V6 or the V8 engine but, the ECT sensor should be next to the thermostat housing or on the drivers side of the engine between the back two spark plugs.


Where is the speedometer sensor located on a 94 caprice?

The sensor on the 1994 Chevy Caprice is located on the transmission. it is mounted on the tail shaft of the transmission.


Where is the knock sensor located on 93 Caprice Classic?

on the side of the engine block, on 1994 and later models, there are 2, one on each side on the side of the engine block


Your engine keeps on overheating but you changed the thermostat water pump and the coolant temperature sensor what do you do?

stop an engine


Oil pressure sensor for 91 Chevy Caprice 5.7 350?

It's on the top rear side of the engine, near distributor.


If you have changed erg valve o2 sensor gas cap but engine lights back on what can you do?

I changed erg valve o2 sensor and gas cap but lights back on what do I do


What is the most common sensor to go out on a 93 Chevy caprice?

o2 sensor


Where is the knock sensor located on a 1996 Chevrolet Caprice Classic?

It is on the side of the engine block. By the way, they very seldom go bad. The purpose of a knock sensor is to pickup engine noises and retard ignition timing so that it will not be so audible.


1991 Chevy caprice recent engine swap and now the motor idles up and down and sometimes start and shuts off.?

Same with my 1993 Chevy Caprice. Right now I've heard it could be one of the following: Idle Air Control(IAC), Fuel Filter, EGR, O2 sensor, MAP sensor, TPS(changed mines but still surging) and the costly of them all the intake manifold is leaking!


Where is temperature sensor located?

Answer , location of temperature sensorI just changed the Temperature sensor on my Pontiac and it was located on the engine block right underneath the throttle control.


What does it mean when black smoke comes out of driver side exhaust pipe on 1994 caprice?

Is your check engine light on ? If it is then have the engine scanned with an engine scanner. Black smoke means engine/fuel system is to rich./to much fuel. Could be the MAP sensor,Fuel pressure regulator, coolant sensor. You need to scan the engine.


What are the signs that an oxygen sensor needs to be changed?

The check engine light will illuminate with a code(s) directing which O2 sensor is bad.


Why does the check engine light stay on after I changed the oxygen sensor on my 1989 Buick Park Avenue?

Need to know what code(s) were set and which O2 sensor you changed in order to help you.


Where is the speed sensor on a 1982 Chevy Caprice?

Its in the transmission


1991 caprice classic oil sending unit location?

driver side above the oil filter> its a long sensor that screws into the engine block


Why does my engine light stay on after you changed the camshaft sensor?

More than likely it needs to be reset.


Where is the crank sensor located on a 1989 caprice classic?

depending on what engine you have, 4.3 v-6 or 305 v-8 or if your lucky the 350......chevy never ran a crank sensor on an engine that old. If it wont start, check spark, if you have spark, check fuel.


Where is the crankshaft position sensor located on a 1996 Chevrolet Caprice Classic?

It is attached to the timing cover, just behind the harmonic balancer, on the lower part of the engine.


What is the difference between 2002 and 2005 dodge neon engine?

If you are asking about the 2.0L engine....the ECM was changed to what is called a NGC and the crank and tone wheel(pickup for crank position sensor) was changed. Also, the blocks are not interchangeable due to the position of the crank sensor was changed. It may be possible to change the crank and and sensor then extend the harness to reach the front of the engine where it was move from the rear starting in 2003 but this would be alot of work. Everything else on the engine should changeover fine.


Why would check engine light stay on after crankshaft sensor is changed when code said crankshaft sensor is bad?

Check to see if the wiring is damaged.


How do you change a camshaft sensor in a 98 dodge stratus with a 2.5L V6 slapstick engine?

The cam sensor is part of the distributor, the entire distributor needs changed. You can not get the cam sensor separately.