All the bulbs will go out.
In a series circuit, the current at all points is the same. This is Kirchoff's Current Law. If you loosen or remove a bulb in a series circuit, the current at that bulb becomes zero, and by Kirchoff's Current Law, the current in every part of the circuit also becomes zero.
The circuit becomes open and hence the other bulbs too stop working.......
Since it is in series, and you have effectively broken the circuit, none of the lights will work.
increase.
There are four types of circuit: series, parallel, series-parallel, and complex.
A series circuit is actually in series, but a parallel circuit, is Parallel
series circuit
-- In a series circuit, no matter where you install the ammeter, it will always read the same current. -- In a parallel circuit, the ammeter may read a different current when it's moved to a different parallel branch.
series resonant circuit
In a series circuit, if another bulb is added, it is going to dim.
Any gap in a series circuit causes the whole thing to stop working. That is why houses are wired in parallel with each other, and indeed there are many parallel circuits inside each house.
increase.
If one wire was to break only one of the bulbs on the circuit would stop working whereas if one wire broke on a series circuit all the bulbs would stop working.
circuit breaker and fuses used in series to break the circuit in overcurrent situation to block current to flow through circuit.
There are four types of circuit: series, parallel, series-parallel, and complex.
A series circuit is actually in series, but a parallel circuit, is Parallel
Series, because everything in the circuit is in series.
Nothing would "happen" to them, but they would glow less brightly.
If it is connected in series with a circuit then it might raise the resistance too high and fail the system. Parallel connection is a circuit is probably the best bet you have.
the electrons are not allowed to enter into the circuit.