answersLogoWhite

0


Best Answer
Copy

IF IT has a pick-up in the Distributor.IF not t could B a Crank sensor.

User Avatar

Wiki User

โˆ™ 2005-01-07 21:34:29
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +5 pts
Q: What would keep a 2001 Chevy Blazer 2wd 4.3 liter from getting spark if the coil and module have been replaced and the fuses are ok?
Write your answer...
Submit

Related Questions

Where is the ignition control module located an a 1983 Chevy blazer?

Where is the control module located on the 1983 Chevy blazer


94 blazer transmission control module?

Where is the tcm in a 1994 chevy S10 Blazer


Where is the transfer case control module in a 1993 Chevy blazer?

That year did not have a controll module.


How do you change an ignition module in a 1993 Chevy blazer?

your a fatty


Where is the ignition switch module located on the 1988 Cherokee limited?

module locatedwhere is the module on a 9 Chevy blazer


When should you have your timing belt replaced on your 1999 Chevy blazer?

Your 1999 Chevy blazer doesn't have a timing belt.


How do you bypass the ignition module to crank a 2000 Chevy blazer 4.3?

It will not run if you bypass the ignition module (no spark).


What would cause the 4 wheel drive to not engage on a 95 Chevy Blazer the module containing the 4x4 button was replaced the light does go on in 4 wheel hi 4?

the transfer case motor has to be replaced


2000 Chevy blazer transmission control module located at?

it on the fire wall


Where is a ignition control module a 1987 Chevy blazer s10?

The ignition module is located in the distributor, under the distributor cap.


Can you clean the oxygen sensors on a Chevy blazer?

No, they will need replaced if defective.


Where is the module in a 1991 S 10 Chevy Tahoe blazer?

under the distributor cap


We replace the temperature gauge in my Chevy blazer what should it read for it to not be over heating?

We replaced the temperature gauge in my 1991 Chevy blazer what is the normal operating temp?


How do you replace a 1994 Chevy S-10 blazer transfer case control module?

where is it at


Where is body control module in Chevy blazer 2001?

Inside the center console, up front.


How do you change the Ignition Control Module in a 1995 Blazer S-10?

Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.


How do you adjust the idle on 1992 Chevy s10 blazer?

You don't, it is done by the ECM (Engine Control Module).


1997 Chevy blazer won't start after it rains what is the problem?

Ignition control module.. located under the distributor The distributor cap is probably cracked and moisture is getting into it. Replace the cap .


Replaced fuel pump on 1990 Chevy blazer and still will not start?

does that year have carb or tb?


What causes a 1993 s10 Chevy blazer to stall while driving?

Need to replace the ingnetion module in the distributor.


Where is the fuel gauge sending unit on a 1999 Chevy blazer?

In the tank, it's called a fuel pump module.


Will the doors from a 98 Chevy blazer fit a 2001 Chevy blazer?

Yes, the doors from a 98 Chevy Blazer will fit a 2001 Chevy Blazer with a little moderation.


Where is the electronic spark control module on a 93 Chevy 4.3 s10 blazer?

I believe in 93 they had the newer style computer, this eliminated the electronic spark control module.


Where is the fuse or relay for power windows in 2002 Chevy blazer?

The fuse or relay for power windows on a 2002 Chevy Blazer is located under the dash near the emergency brake. It can be readily replaced by pulling it out.


Why is a 2001 Chevy blazers not getting fuel to the carb?

A 2001 Chevy Blazer does not have a carb. It is fuel injected and has a throttlebody. If the fuses and relays check okay and the fuel filter has been replaced, I would suspect the fuel pump has failed.