0
Add your answer:
Earn +20 pts
Are you srart Naruto session 3 yes or no?
No.
What time does super bowl 2010 srart PST?
now
Wont srart no spark?
check your spark plugs and find out if one is fryed other than that i got NOTHING with out more info
Is the quotient of two fractions greater or less than the fractions you srart with?
It is greater as for example 3/4 divided by 1/4 is equal to 3
What year did the 2nd world war srart and Finish?
For the United States WWll started on December 8, 1941 an ended on August 15, 1945
Is there a list of the little ships from Dunkirk or is there any record of which 'little ship' carried which soldiers?
can any one help me i have a yheames sailing barge the tollsberry and need to sell it but don't know where to srart i belive its one of the little ships from Dunkirk
How do you unlock VIP Commander MSL briefcase 3 digit lock?
If the case is new 0-0-0 will open it. If not you have to crack the combination which is not to difficult on a three digit lock. start with likely number sets if that doesn't work srart counting up from 000 to 999, it can't take that long.
Why does the heater blow cold and not hot on 95 Chevy 3500?
check thermostat to be sure enging is getting hot. Heater control on dash opens doors to direct air flow. check that cables are working behind the dash control. you should hear the doors open and close. Also there are vacume operated doors. Srart with replace vacuve lines on engine. At the front of vans, as you open the hood there is a round plastic vacume chamber. It is easy for the vacume line the come off there. There are "vacume engines" that make use of the vacume to open the doors. These can wear out. Mine has always been vacume lines either broken or disconnected.
Is there any way to get a 3-phase motored 15hp 120 gal compressor to work on any kind of residential hookup?
If the motor voltage is 240 you can hook 240 to any two motor leads then put a switch and a capasitor in series from one leg to the other motor lead.once motor starts open switch,the motor will be rated at 58% about 8.7 hp.Another way to do this is if you have another 3 phase motor the same size or larger ,hookup 240 to extra motor any two leads hook leads from motor to air comp start contactor.Turn shaft on extra by hand it will srart which will make a third leg "3 phase" I know this is working on a three phase wheel balencer for the last 8 years i don't believe i would want to "hand spin" a motor on a compressor... a bit hazardous! another factor here is the direction of rotation as most compressors are sensitive to this. the starting current on a motor of this size and the service it is in quite large, the best bet would be to find a replacement single phase (220V.) motor (matching rotation, speed and starting torque). one could always use a rotary phase converter, but this is a spendy and involved way to do the job.
Why would a 88 Ford Ranger that was in excellent condition it just quit and not start it?
check battery terminals for corrision my bronco II was famous for this. the battery was charged but wouldn't start. clean inside the cable connection and battery post with sandpaper. also check the clutch pedal switch has broke or come loose (if you don't push in the clutch the car won't start) I had this happen on a mustang the switch had cracked and this was after I replaced everything else in the carAnswerSounds like a coil or ignition model. Answerwe are finding in the ford Rangers when they run greate and just stop that nine out of ten times the fuel filter has never been changed changed filter they are $8.00 please e-mail me let me Know results. AnswerCheck the fuse box, number 18 is for the fuel pump... AnswerMy 88ranger would do that about once a month. I had a bad inerta switch, the switch that shuts fuel off if you get in a wreck. Its right under neath the carpet on the passenger side push the button on top and it sould reset. AnswerHad this problem only once. I had to replace the fuel pump relay on the right fender liner behind the air filter box. I do believe it was the grey one. I had already changed out the distributor module. Neither part, was high dollar. The distributor module can be decieving and cause the motor in excellent condition to not srart. There's a little wire underneath the dash on the passeneger side that is exposed. If someone with long legs sits in the passenger seat, they can knock it loose which can cause the truck to quit and not start again. If that's your problem, just plug it back in, and everything should be fine.AnswerHad the same sort of problem on my 91 ranger. Runs great for several weeks then one day doesnt start. No click, no turn, nothing. After finally getting it to start (still don't know what i did) it runs great for several more weeks , then doesnt start again....had this problem for several months. Finally dished out the cash and had battery, baterry cables, starter, and start rely changed. Ran great for several weeks , then guess what...YEP, wouldn't start!! Just put in a new switch (on the clutch pedal) and so far so good... AnswerI had the same problem with my 88 Ranger. The problem was the wiring harness on the fuel pump shut off which was located under the carpet on the passengers side where their feet would be. Wiggle the wire and it would go. I had this happen a few times to while driving down the highway. Not fun!!! Answercheck the time chain or belt (may have jumped a tooth or broken)
