Does not have one. The engine uses cam overlap to achieve the effect of the EGR valve.
Valve timing overlap is the time when both exhaust and intake valves are open most engines with catalytic converters require valve overlap in order to send a small amount of raw fuel/ air mix to the converter's. An "open cam" has valve overlap a "closed" cam does not
A trading area-overlap occur when the trading areas of stores are in the same location, they both serve the same customers.
I don't know about maximun, but I do know that maximum is greatest or in other words, the largest. If you meant maximun, sorry, I don't have an answer.
It improves the efficiency of the engine by allowing better exhaust out flow and intake in flow.
Valve overlap.
Valve overlap occurs in a four-stroke engine at the end of the Exhaust stroke and at the beginning of the Induction stroke; and is when both the exhaust and inlet valves are open at the same time. At the end of the Exhaust stroke, the Exhaust valve is closing and the Inlet valve is starting to open in preparation for the induction of fuel and air into the cylinder. It is common knowledge that in vehicles that cannot alter the valve timing, the Inlet valve opens approx 6 degrees before top-dead-centre and the Exhaust valve closes at 9 degrees after top-dead-centre
s/sp2p/psp/sp2sp/sp
is the greaters number
What is the maximun interest fee on a pawn loan in CA?
send a small amount of raw fuel/air to the catalytic convertor,which increases the efficiency of the operating engine.
High end Rpm output tails sooner, engines idle is lumpy, emissions are higher, too much overlap can cause rough low rpm driving, more chance of detonation.