The questions is disjointed that it is impossible to answer....you need to be clear what is wrong and what you want The car is on? Are you sure it's not just the daytime running lights?
Bulbs are replaced from rear of headlight. See answer to similar questions for how to do.
Headlight bulbs, high and low beam, parking light bulbs, signal light bulbs, brake light bulbs, dash light bulbs, interior light bulbs, plate light bulbs, etc.
There is a campaign on the brake bulbs for 2000-2003......If it hasn't been done you should get it done. The bulbs and sockets will be replaced.
Check sockets and grounds
The headlight bulbs on a 1992 VW Golf are replaced by pulling the wiring harness on the rear of the bulb and twisting the bulb. The bulb can then be removed and a new bulb locked into place.
i have tail lights but do not have brake lights nor do i have turn signals. i have replaced brake switch and all bulbs
use BMW bulbs and parts
The fuse may have blown. Be sure the bulbs are good.
Check the bulbs,if not the bulbs you most likely have a bad ground.
Working brake lights are important for safety reasons while driving. It is important to check all of the wiring, if the brake lights are not working and the fuses and bulbs have been checked.
check the wires at brake light switch on brake pedal they are bad about breaking brake light switch
There might be a separate fuse for the lower brake lights ( just a guess )
Check the bulbs first. I had the same problem on a 94 Oldsmobile and it was the dimmer switch. Replaced that and fixed the problem Check the bulbs first. I had the same problem on a 94 Oldsmobile and it was the dimmer switch. Replaced that and fixed the problem
The VW polo has headlight bulbs. If the headlights are not working, it may be a bulb has burnt out.
Before replacing the headlight bulbs on a 1997 Acura CL prop the hood open. Locate the headlight housing and remove the old bulbs. Install the new lights.
Headlight switch (IT) controls the dash lights ALSO.Some have a fuseable link..ASSUMEING all the bulbs are g00d..
Likely to be the brake light switch on the pedal at fault if the bulbs and fuses are good and other lights work ok.
9004 Headlight Bulbs
How about a malfunctioning brake light switch
To change a car headlight prop the hood open. Locate the headlight housings which will be towards the front of the vehicle. Find the bulbs and unscrew them. Insert the new bulbs.
There are three main types of headlight bulb: Filament HID LED Filament are traditional bulbs, using a metal filament surrounded by halogen or xenon gas. Standard bulbs are normal, but headlight bulbs of up to twice the brightness, such as Osram Night Breaker are also available. HID use an arc of electricity, and are on some high end cars. Available as an upgrade, you need to add a ballast unit and a new bulb, so not a direct replacement. LED is only just becoming mainstream. No upgrade path from standard bulbs, as they need carefully designed fittings and controls to make them bright enough for main headlights, although they are common in sidelights, tail, brake and indicator bulbs.
I just had my Daewoo Leganza brake light switch replaced. It goes under the brake pedal. and now my brake lights work fine.
Try replacing the headlight switch. Do the front parklights work and not the rear ones? If so check the harness to the rear of the vehicle for breakage.
I hate to ask , but did you check the bulbs ? The tail light portion may work fine , but the brake lights don't if both of the bulbs are bad .