Nissan

When fixing a blown head gasket do you have to replace the manifold gasket on a 1991 Nissan pickup truck?

123

Top Answer
User Avatar
Wiki User
Answered
2008-12-22 01:42:50
2008-12-22 01:42:50

If it was removed then YES.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Yes, remove the intake manifold and replace the gasket. It can be done with a basic mechanics tool kit.

Remove the manifold and change the gasket. And voila!!!

No. which manifold gasket are you wanting to replace? Intake or exhaust?

Replace gasket why does gasket keep sliding

Yes, you must install a new intake manifold gasket.

The gasket is between the head and the manifold and simply remove the bolts and replace the gasket after cleaning it real good.

You have to replace the gasket because when you take the manifold off it brakes the seel and air will be sucked into the manifold and your vehicle will hardly run, and you wont be able to drive it You have to replace the gasket because when you take the manifold off it brakes the seel and air will be sucked into the manifold and your vehicle will hardly run, and you wont be able to drive it

unbolt the head pipe then the manifold.

The labor charge to replace and intake manifold gasket, on a 1999 Chevrolet Tahoe, is approximately $180. It takes approximately 2 1/2 hours to replace the gasket.

how to replace a distributor gasket on a 2000 Pontiac grand am 3.4l

The manifold gasket is the same as the plenum gasket. The manifold gasket is a barrier between the manifold and the engine block.

Remove the intake manifold retaining bolts from your 1996 Chevy Astro Van. Remove the manifold gasket and clean the surface. Reverse the process to install the new intake manifold gasket.

Pretty straight forward. You must remove the intake manifold in order to replace the gasket.

the knock sensor is located under the intake manifold, with a flash light you can see it however you have to remove the intake manifold to replace the knock sensor , also you will need to replace the intake gasket set as well!

In most cases a new gasket is required, but no sealant.

If the exhaust manifold gasket is leaking the only fix is to replace it with a new one.

there is no lower intake gasket, only a front and rear gasket

The only fix for a bad intake gasket is to remove the intake manifold and replace the gasket.

Remove everything on top of the intake (hoses, fuel rails, linkages.) Unbolt the manifold and remove it. Clean the old gasket off and replace it. Reinstall all parts removed to get to the gasket.

You must replace the defective gasket. There is no other permanent fix.

if it is just a blown exhaust manifold gasket it can ruin your valves, so replace it correctly and make sure everything is clean before putting on the new gasket

Your intake manifold gasket needs to be replaced.

Gain access to the manifold area, Unbolt the 6 bolts holding it on. Seperate the manifold from the engine and scrape off the old gasket, sand it down with emery cloth, Make sure to keep debris from going inside the chamber. Insert the new gasket and get the manifold close then wiggle it around till you can get a few bolts in then thread the rest in. torque them down to spec and your done.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.