Ford Focus
Heater Cores and Blower Fans
Ford Expedition XLT
Heating Ventilating and Air Conditioning

When lowering the fan from 4 to 1 for the air conditioner in a 2000 Ford Focus what could cause it to stop working completely?


Top Answer
User Avatar
Wiki User
Answered 2008-12-01 03:06:55

the problem is a resister . Mine went bad doing the same thing . It is located behind the glove box to the left of the blower motor housing it should be blue in color. I had to order it from Autozone


Your Answer

Related Questions

nearside sidelights not working on ford focus

why 2003 ford focus stall when air conditioner is turned on

The low side air conditioner pressure valve is located on the top of the accumulator of the Ford Focus 2005. This is located in the front of the passenger wheel near the bumper.

Yes, it is possible to add an air conditioner to a 2004 Ford Focus. One would have to contact local mechanics to find one that install after market air conditioner systems.

The recharge prot is on top of the "drier", which is located under the passenger side wheel well. Will-

By focusing upon building your self-esteem you in fact stop the cycle of lowering it. Whatever you focus upon you in fact attract into your reality. And so the very first step is to change your focus and them you will begin to notice the many ways in which you can grow in confidence and self-esteem.

Conditioner. It has more added nutrients and oil tends to make hair greasy. Conditioner has just the right amount of oil to make hair healthy, but when you condition make sure to focus on the ends and avoid the roots. And use a leave in conditioner after every wash.

Improving conditions for the working class.

It's when you focus on something , and put all of your work into it .

the air conditioner is located in engine compartment attached to motor. the compressor is located passenger side front of engine underneath alternator it is hooked up to same fan belt.

order the belt for your car and say it does not have ac

imagine a small flame in your mind's eye. focus on the flame. if you lose focus, don't worry just keep focusing.

Most webcams will automatically focus on the main thing in front of them. If this is not working you will need to open up the software that is controlling them and manually adjust the focus which is usually in a section labelled Focus or Mechanics or some such.

Because if you are looking in the eyepiece and the view is out of focus you might already be too low and about to damage the objective.

Working conditions and wages and benefits

Working distance or WD is the distance between each objective and the specimen, when precise focus of the specimen is obtained.

it wouldn't be the best idea because you can't really focus while working so technically no.

Could you specify what exactly is working improperly, and what it is that it is doing wrong? There is a pretty broad spectrum of possibilities there.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.