answersLogoWhite
Serpentine Belts
Chevy Silverado
Jeep Grand Cherokee Laredo
Pontiac Grand Am

When replacing a fan belt for a 1997 Pontiac Grand AM where is the pulley located?

676869

Top Answer
User Avatar
Wiki User
2006-07-20 04:39:16
2006-07-20 04:39:16

Which engine do you have? In any case; there is no fan belt us older types remember. The fan is electrically powered and controlled by the car's PCM (computer). The car does have a serpentine belt that drives the alternator, power steering pump, water pump, and air conditioning compressor. It is spun by the engines crankshaft pulley and routes to the accesories mentioned above. there might not be a pully controlling the radiator fan because of the newer cars these days some engines like the pontiac,sits side was so the fans not belt drive it s eletricaly driven to replace you may have to re place the fan motor which is attached to the radiator by to or four bolt s the worst on some cars is how much room you have to pull the fan out once it s free.sometimes there are tight squeezes... GOOD LUCK.

1

Related Questions

User Avatar

its the first pulley on the passenger side of your engine the pump is located behind it

User Avatar

were is my 1999 pontiac grand am map sensor location

User Avatar

Should be just above and in line with crankshaft pulley

User Avatar

Where are the vacuum hose located at on '97 Pontiac grand am? Where are the vacuum hose located at on '97 Pontiac grand am?

User Avatar

Where is the shift solenoid located on a 2004 pontiac grand prix

User Avatar

You will have to replace the regulator assembly.

User Avatar

Where are the freeze plugs on a 2003 pontiac grand am

User Avatar

were is the crankshaft sensor located on a 1987 Pontiac Grand AM with a 2.5L engine

User Avatar

Grand? As in Grand Piano?? I can Play that for you ^^

User Avatar

Where is the motor mount located on 1995 grand am

User Avatar

1996 2.4L Pontiac Grand AmWhat year, engine, model?

User Avatar

where is valve cover located on a 2001 Pontiac Grand-Am 4 cyl

User Avatar

you will need a pulley puller, pull off the pulley when you replace just bolt it back in place it might take a little muscle to get it started.

User Avatar

The thermostat is located near the intake on a 1999 Pontiac Grand Am GT. The thermostat can be located by following the upper radiator hose directly to the thermostat.

User Avatar

where is the antenna located on a 1999 pontiac grand prx gt

User Avatar

The EGR valve is located on the side of the intake on the 2000 Pontiac Grand Am. It is close to the intake manifold.

User Avatar

on a 1998 Pontiac gan am ,they do not have a pcv valve.

User Avatar

Pontiac Grand ams dont have an inertia switch, actually no GM cars that i know of have them.

User Avatar

........above the steering wheel?

User Avatar

The PCV valve is located under the MAP sensor on a 1990 Pontiac Grand Prix. The MAP sensor is in the upper plenum.

User Avatar

You will need to loosen the tensioner pulley on your 1994 Pontiac Grand Am. The old serpentine belt will come loose and can be removed. Put the new serpentine belt on and tighten the tensioner pulley.

User Avatar

where is the flasher relay located in 2004 grand am

User Avatar

The 2001 Pontiac Grand Prix fuse box is located in the engine compartment. The fuse box will be on the back side of the battery box.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.