"How do you unhook a hot tub that was connected to an '''outside electrical outlet?'''" .... Just unplug it
did you unhook the battery before replacing the alternator
unhook both battery cables for a few minutes
You unhook the two wires that lead from the ignition to the electrical.
Empty it, unhook the hoses and wires then unbolt the straps holding it on.
unhook positive batery cable for 5 mins
What did unhook or break while you were under the hood ?
You need the removal U tool from a local auto parts store,(a couple of bucks) and push the two U tools in each set of holes in the side of the radio and pull out far enough to unhook the electrical connections.
You do not need to fool with the steering wheel or air bag...just unhook the battery for 15 minutes before you work on it anyway. You need to take the three screws out of the plastic shroud around the switch and turn siganl assembly. Then take out the three torx screws (special ones with the post in the center...anti tamper) out of the switch. Unhook the two electrical connections and it will come out easily.
Master reset for what? Be more specific. unhook the negative cable from the battery for 30 seconds
Yes, just do not weld on the fuel tank and unhook the battery to prevent electrical failures.
No, but unhook the battery and wait 15 minutes to let the system power down.
Please unhook the latch for me.
when you unhook the battery the computer probably resets itself.
The duration of Unhook the Stars is 1.72 hours.
Take the door panel off,drill the rivots,after you unhook the wiring,work the motor out
You can't, the gradually unhook themselves, in an hours time
Unhook the Stars was created on 1996-09-04.
Reach under the front of your car between the radiator and the grill and pull the wire down. That will unhook your hood latch. Replace the cable.
unhook battery connections, wait 5 minutes then hook them back up. If that doesn't work you, you still have an engine problem that needs fixed.
There is 2 large plastic screws that hold the headlight assembly`s in. Simply unscrew them and lift the headlight assemblies out then unhook take the bulbs out.
Use a small ratchet with a 9mm socket and rotate clockwise. The terminal connections will come right off. Make sure to take the positive (red) connecton off first.
Why would you want to unhook the Electronic Spark Timing?
no you don't need to reset the computer. but it is always a good idea to reset it when replacing any censors. just unhook the battery cable( negative) for 30 seconds then put it back on and drive 50-75 miles to reset the computer.