Send it the SIGQUIT signal.
Performance Monitor ~Chute~
There are several different parameters one can use for measuring various statistics about paging and swapping. -S, -W, and -B are all related and display slightly different statistics.
show ip int brief
, the Ping command provides you with a parameter that configures the command to continuously ping the target device until you manually terminate the operation:Ping -t xxx.xxx.xxx.xxxIn this command, xxx.xxx.xxx.xxx is the IP address of the target device.To temporarily interrupt a continuous Ping operation and display the statistics, press [Ctrl][Break]. To completely terminate a Ping operation, press [Ctrl]C.
the command "display" brings up the ImageMagick program.
Statistics
The time command is used to time a command and not display the actual time. To display the time and date, the date command must be used.
display command help to display the single current record in a database where as list command helps to display all the current record which are present in a data base.
If you want to run something on an existing X display from a console the correct syntax is: DISPLAY=":0.0" (command) Of course, it might just be easier to go to your X display and run your command from there.
hostname.
ifconfig
SAR is a command in Linux that serves as a heads up display for the activity of your CPU. There are roughly 40 different syntax you can add to the command to display specific variables of interest.