If a standard transmission vehicle makes a different sound when you press the clutch it usually means that the throwout bearing is about to seize.
Throwout bearings are permanently lubricated and as such do not have a grease fitting. If the bearing grinds when you press the clutch your throwout bearing is trashed. Since it only makes noise when your clutch is rattling around, it's just an annoyance. If it gets to the point where it makes noise when you press the clutch you need a clutch job.
The clutch is the pedal you press to change gear.
hi i want to know why when i press the clutch i hear noise
When you let the clutch out all the way, if it continues to slip, it's worn out. A slipping clutch indicates that the clutch wear surface has gone. Plan on replacing the clutch disk, pressure plate, throwout bearing and have the flywheel resurfaced. While it's apart, it wouldn't be a bad idea to replace the clutch master and slave cylinders as well. If the clutch will not release when you press the pedal, it could be a warped clutch disk or pressure plate or a faulty hydraulic clutch system (master cylinder/slave cylinder).
It is probably the throw out bearing going bad. You have to remove the transmission from the bottom to replace it. Replace the clutch, pilot bearing, and throw out bearing and have the flywheel resurfaced.
Yes and self adjustable, and heavy duty clutch, thus when you press the clutch in, its quite heavy
Put the card in, press the brake or clutch and press start
A worn out clutch release bearing would cause a whining sound when you put your foot on the clutch.
It might have a problem with the neutral safety switch, (it's what is switched on when you press the clutch) The switch is behind clutch pedal. It looks a lot like a brakelight switch. If it's bad, the part is about 40 or 50 dollars. Good Luck!!!
a flywheel and clutch which is on the same shaft and a motor (which rotates the flywheel),also a ram(the moving assembly of press) is connected to the clutch..when motor rotates the flywheel and we apply electrical supply to the clutch..the clutch engaged with the flywheel.we get a motion into the ram.................................................................................................................................................................hun etho simple ni koi das sakda.............................
press the button
Hold clutch then press pass